W.B. Jones #81 SPRINGS WBJ 81
Jones 81 Extension Spring, 0.38 in ID x 0.562 in OD, 3-1/4 in OAL, Steel
-
BrandJones
-
Manufacturer Part Number81
-
CountryUSA
-
Capacity26.81 lb
-
FinishZinc Plated
-
MaterialSteel
-
Wire TypeHard Drawn
-
Inside Diameter0.38 in
-
Outside Diameter0.562 in
-
End StyleMachine/Loop
-
Overall Length3-1/4 in
- Developed to absorb and hold energy, extension springs also supply resistance to a pulling force
- The required tension determines how tightly an extension spring must be coiled
- This initial tension can be adjusted to meet the load requirements of a given application
-
UNSPSC31161907
-
Package Description6/PK
-
Catalog
Recently Viewed
Jones 81 Extension Spring, 0.38 in ID x 0.562 in OD, 3-1/4 in OAL, Steel
Milton 1838 3/8" FNPT H style plugs are made of case hardened steel and are plated to resist rust. Milton H style plugs have a 3/8" basic flow size and a maximum pressure of 300 PSI. With air flow of up to 67 SCFM, H style couplers and plugs are perfect
3/8 in FNPT H-style Plugs are made of case hardened steel and are plated to resist rust. Milton® H-style Plugs have a 3/8 in basic flow size and a maximum pressure of 300 psi. With air flow of up to 67 scfm, H-style couplers and Plugs are perfect for larger tool applications that require more scfm.
IKO manufactures a wide range of radial Needle Roller Bearings to meet the needs of different applications and machine profiles. These include shell type bearings, needle roller cages for both general use and within engine connecting rods and machined type Needle Roller Bearings. Shell type Needle Roller Bearings are lightweight, low profile motion components designed to handle either high speeds or heavy loads, depending on the configuration. An outer ring made of high strength steel enables a streamlined profile with the lowest sectional height of all the Needle Roller Bearings.
Wear protection products extend the life of slings by reducing exposure to abrasion and other similar forms of sling damage. Wear pads also help protect load surfaces from damage along points of contact.
McGill® CAGEROL® machined race needle bearings are manufactured from bearing quality steel. Most sizes use crowned or end relieved, rollers to help reduce end stresses and allows for greater misalignment. The rollers are separated by a steel retainer (cage) to help achieve higher speeds and provide a lubricant reservoir. CAGEROL® bearings are constructed with radial lubrication hole and groove on the outer and optional inner raceway (MI series) for relubrication through the housing or shaft. Other options include a variety of seal configurations to either help prevent contaminant entry or contain the lubricant.
Sioux Chief Raise-A-Ring™ 886-R Spacer/Extension Ring, ABS
Installers use Sioux Chief's spacer and repair rings to repair or adapt closet flanges for specific applications, such as when new or thicker flooring is added. The Quick Spacer™ installs under the flange, while the Raise-A-Ring™ is typically set on top of the flange, and can be stacked if necessary. For repairs to cracked or broken flanges, installers can fit Sioux Chief's stainless steel Ringer™ over the damaged flange and fasten it to the floor. Also available is a two-piece repair ring, designed to replace rusted or broken metal swivel rings without replacing the plastic portion of the flange.
