OK-1 FINGERLS ANTI-VIBRATION GLOVE OK1 OK-GAV-L-L
LARGE LEFT IMPACT RESIST GLOVES-OK1GAVLL>
Recently Viewed
LARGE LEFT IMPACT RESIST GLOVES-OK1GAVLL>
GLOSS DARK GRAY SPRAY PAINT-RUS1986 >
These heavy duty, tough, and dependable stack and nest totes are the ultimate reusable container for storing and transporting your valuable items in any application. These proven containers are available in nine sizes and three colors for efficiency and inventory control. Available in: blue, gray and red.
BBI 455280 Partially Threaded Cap Screw, 7/16-20, 4-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455280 Partially Threaded Cap Screw, 7/16-20, 4-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
Milwaukee® SAWZALL® 6520-21 Grounded Corded Reciprocating Saw, 1-1/8 in L, 0 to 2800 spm, 18-3/4 in OAL
The new Milwaukee® 6520-21 orbital SAWZALL® reciprocating saw offers best in class performance in the most important respects including speed, durability, power and ergonomics. The variable speed trigger provides 0 to 2800 SPM with a 1-1/8 in L stroke. The 6520-21 also comes equipped with orbital cutting action allowing the tool to cut faster than the competition. A gear protecting clutch allows the saw to withstand impacts lengthening the life of the tool. The 13 A Milwaukee® built motor offers enough power to handle even the most extreme cutting applications. The QUIK-LOK™ blade clamp provides fast and easy blade changes and an impact-resistant carrying case provides room to store A variety of accessories.
Koyo IR-88 Inch Series Regular Width Inner Ring, 1/2 in ID x 3/4 in OD, 0.515 in OAW, For Use With B-126, B-128, J-126, J-128, M-1261, M-1281 Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
