1-TA-58 Single Groove A-belt Sheave For Use With All " A" Belt 6.05
SINGLE GROOVE A-BELT SHEAVE FOR USE WITH ALL " A" BELT 6.05 OD-BRW1TA58 >
Recently Viewed
SINGLE GROOVE A-BELT SHEAVE FOR USE WITH ALL " A" BELT 6.05 OD-BRW1TA58 >
Proto® JSCR16T Non-Reversible Spline Combination Wrench, 1/2 in Wrench, 12 Points, 15 deg Offset, 7 in OAL, Forged Steel, Full Polished, ASME Specified
ILSCO® NIMBUS® PBTS-2-500 Type PBTS 1-Sided Entry 2-Port Dual Rated Insulated Multi-Tap Connector, Aluminum/Copper Conductor, Aluminum
ILSCO® NIMBUS® PBTS-2-500 Type PBTS 1-Sided Entry 2-Port Dual Rated Insulated Multi-Tap Connector, Aluminum/Copper Conductor, Aluminum
2" X 3/4" GALVANIZED BUSHING-JPW2X3/4GB >
Lift-All® Roughneck® 4T210X8 Triangle/Triangle Wire Mesh Sling, 8 ft L x 4 in W, 4800 lb
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
