CHICAGO RAWHIDE 16315 1.625" X 2.623" X .313"
1.625" X 2.623" X .313" DOUBLE LIP OIL SEAL, NITRILE RUBBER MATERIAL-CHI16315 >
Recently Viewed
1.625" X 2.623" X .313" DOUBLE LIP OIL SEAL, NITRILE RUBBER MATERIAL-CHI16315 >
The 5000® Series of bearings is similar in construction to the 400® Series bearing except it has a flange on the outer ring to locate the bearing when pressed into a tube or housing, thus eliminating the need for an external mounting device. The bearings are designed for moderate loads and speeds where running accuracy and noise level requirements do not warrant the more expensive precision ground bearings. This series of bearings feature a full ball complement without a retainer. The rings are case hardened and the soft steel band on the outer ring of the unitized assembly allows the bearing to be pressed into a housing without the necessity of close housing tolerances. The bearings are supplied pregreased as a standard. The bearings are designed for use in applications with speeds not exceeding 1200 rpm.
Browning® 767495 VPS 300 Medium Duty Pillow Block Ball Bearing, 1-7/16 in Dia Bore, 5-5/64 to 5-63/64 in L Bolt Center-to-Center, 2-1/8 in Base to Bore Centerline, 7-1/4 in OAL x 4-3/16 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
HCI Preferred Supplier 40027 Standard Pipe Nipple, 1/4 in Nominal, 4-1/2 in L, Brass, NPT End Style
HCI Preferred Supplier 40027 Standard Pipe Nipple, 1/4 in Nominal, 4-1/2 in L, Brass, NPT End Style
Browning® 767923 VPLE 200 Normal Duty Pillow Block Ball Bearing, 1/2 in Dia Bore, 3-1/8 to 4-1/8 in L Bolt Center-to-Center, 1-1/16 in Base to Bore Centerline, 4-7/8 in OAL x 2-3/32 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
United Abrasives-SAIT Brute™ 23452 Type 1 Burr Free Portable Saw Cut-Off Wheel, 14 in Dia x 1/8 in THK, 1 in Center Hole, 24 Grit, Aluminum Oxide Abrasive
