NCS-1616 1"-ID Needle Bearing Outer
1"-ID NEEDLE BEARING OUTER RACES-INANCS1616>
Recently Viewed
1"-ID NEEDLE BEARING OUTER RACES-INANCS1616>
M12" X 40 SOCKET HEAD CAP SCREWS-HOL76372 >
HCI Preferred Supplier 949162 2-Piece Ball Valve, 3/8 in Nominal, ASTM-A351 CF8M 316 Stainless Steel Body, Full Port, RPTFE Seal/Thrust Washer/Plastic Cover Softgoods
HCI Preferred Supplier 949162 2-Piece Ball Valve, 3/8 in Nominal, ASTM-A351 CF8M 316 Stainless Steel Body, Full Port, RPTFE Seal/Thrust Washer/Plastic Cover Softgoods
1-7/8"-ID NEEDLE BEARINGS-TORB308OH >
DRILLCO 70M042DC 7000M Miniature Carbide Burr, Pointed End, Cone Head, 1/8 in Dia Head, 7/16 in L of Cut, Double Cut
Drillco solid carbide burrs are extremely versatile. Manufactured from premium grade tungsten carbide. Burrs are available in standard lengths (single and double cut), 6" long series, and in miniature sizes (for use in pencil grinders).
Browning® 1296573 T65L Automatic Torque Limiter, 1-7/16 in Finished Bore, 6-1/2 in OD, 4800 in-lb (1-Spring)/8800 in-lb (2-Spring) Torque
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
