VS-220-S 1-1/4" -ID Spherical Outside Diamter Insert Bearing
1-1/4" -ID SPHERICAL OUTSIDE DIAMTER INSERT BEARING-MBUVS220S >
Recently Viewed
1-1/4" -ID SPHERICAL OUTSIDE DIAMTER INSERT BEARING-MBUVS220S >
TRAKROL® bearings feature black oxide treated bearing steel. They utilize either a precision ball or tapered roller bearing insert for longer operating life under combination radial and thrust loads. The capacity for combination loads allows the TRAKROL® bearing to be available in plain (cylindrical), V-groove and flanged outside diameter in both stud and yoke styles. Small sizes less than 3 in outside diameter or point diameter use sealed ball bearing inserts. They also use a NYLAPLATE® seal for additional protection. Stud type configurations utilize a metal end plug seal on the roller face providing a long lasting seal. Both bearing types provide a large internal grease reservoir along with special sealing. This makes TRAKROL® bearings an excellent choice where reduced maintenance is required.
Mayhew™ 21001 PRO™ Pin Punch, 3/32 in Hex Punch, 4-1/2 in OAL, Alloy Steel
3/8" PLASTIC INLINE GAS FILTER - WIX33003>
Gates® Power Transmission PowerGrip® GT®2 Twin Power® TP1600-8MGT-20 9232 Synchronous Belt, 200 Teeth, 8 mm Pitch, 1600 mm OAL, 20 mm W, Neoprene
PowerGrip™ GT™2 Twin Power™ Belts feature dual-sided teeth to provide equal load carrying capacity on either belt surface, enabling synchronization from both driving surfaces. These synchronous belts ensure high loading capacity on contra-rotating drives and ensure smooth running and high flexibility. Gates Twin Power PowerGrip GT2 belts are designed to perform at high speeds and characterized by low-running noise, with a larger tooth profile for increased performance capacity.
Drillco 750A108 Spade Drill, 1/8 in Drill - Fraction, 0.125 in Drill - Decimal Inch, 2XD D Cutting, Solid Carbide
Solid Carbide spade drills perform well in hard to machine materials (up to Rc 60), high strength alloys, plastic, and glass. They can be used in thin sheet metal and spotting applications. Drilling depth should not exceed 2x the drill diameter.
