G-1110-K-RR-B 1-3/4"-ID Sph/OD Insert
1-3/4"-ID SPH/OD INSERT BEARINGS-FAFG1112KRRB>
Recently Viewed
1-3/4"-ID SPH/OD INSERT BEARINGS-FAFG1112KRRB>
Gates® Power Transmission Hi-Power® II PowerBand® 3/C210 Banded Heavy Duty V-Belt, C Section, 7/8 in W Top, 214 in L Outside, 17/32 in THK, EPDM
The wrapped classical section Hi-Power™ V-belt has a long reputation for reliability on agricultural and industrial applications. The arched top of the Hi-Power belt provides superior strength to prevent "dishing" and distortion of the tensile section. The cords are properly aligned, each of them carrying its full share of the load.
Remke Tuff-Seal™ 7303-004R Non-Insulated Wide Range Strain Relief Grip With Mesh, 3/4 in Trade, 0.52 to 0.73 in Cable Openings, Aluminum
Tuff-Seal™ strain relief grips are used to connect cord or cable to electrical enclosures and equipment, power boxes, portable power tools, panel boards and machine tools. For indoor use only in dry locations, these grips help control arc-of-bend and prevent cable pull-out and damage resulting from flexing. Strain is distributed over the length of these grips instead of at a single point. These tuff seal strain relief grips are made with a single-weave, galvanized steel mesh and feature aluminum fittings and a gasket that provides an environmental seal against dust, filings and other foreign material.
1-1/4" X 1/8" X 72" ANGLE STOCK - FOR49481 >
1 3/8" -ID COUPLING FLANGE MAX4500 RPM-LOV8S13/8 >
Browning® 1073725 Type F Q-D® Bushing, 1-1/2 in Dia Bore, 4-3/8 in Dia Barrel, 6-5/8 in Dia Flange, 3.68 in OAL, Cast Iron
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
