327-LS INGERSOLL RAND
PNEUMATIC TIRE BUFFERS/DIE GRINDER-ING327LS>
Recently Viewed
PNEUMATIC TIRE BUFFERS/DIE GRINDER-ING327LS>
7/8" LAMP WICK, FLAT LW5-JWH664103>
BBI 241160 Dowel Pin, 1/4 in Dia x 5/8 in L, Alloy Steel, Plain
GLOSS NAVAJO WHITE SPRAY PAINT-RUS1996 >
KRYPTON 4D AREA LANTERN-JWH802974>
Koyo TRA-1828 Double Direction Thrust Washer, 28.58 mm ID x 44.45 mm OD, 0.81 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
