ITM TX05015 Bit Screwdriver, #T15 Point, 2 in OAL
ITM TX05015 Bit Screwdriver, #T15 Point, 2 in OAL
-
BrandITM
-
UPC703652452912
-
Manufacturer Part NumberTX05015
-
CountryUSA
-
MaterialSteel
-
Catalog
Recently Viewed
ITM TX05015 Bit Screwdriver, #T15 Point, 2 in OAL
ITM 219CO2464 Heavy Duty Drill Bit, 3/8 in Drill - Fraction, 0.3750 Drill - Decimal Inch, 135 deg Point Angle, M35 Cobalt, Gold
ITM 219CO2464 Heavy Duty Drill Bit, 3/8 in Drill - Fraction, 0.3750 Drill - Decimal Inch, 135 deg Point Angle, M35 Cobalt, Gold
Browning® 3748563 Taper Lock Bushing, 1-1/8 in Dia Bore, 1.511 in Dia Barrel, 7/8 in OAL, Steel
Browning® 3748563 Taper Lock Bushing, 1-1/8 in Dia Bore, 1.511 in Dia Barrel, 7/8 in OAL, Steel
75,000-BTU KEROSENE TORPEDO HEATER-DYGRMCKFA75TDGD>
Milwaukee® 49-57-2002 Tang Drive Annular Cutter, 2 in Dia Cutter, 1 in D Cutting, Uncoated, Quick-Change Shank
Drill holes up to 3X faster and enjoy fast change-outs with the Milwaukee® 2 in. quick change tang drive Steel Hawg® cutter. This long-lasting cutter features Carbide teeth and an alternating cutting pattern to cut up to a 1 in. hole depth in steel, stainless steel, cast iron or aluminum. It leaves a ream-like finish without pre punching or pilot holes. The Steel Hawg cutter works with most electromagnetic drill presses. Use it with arbor 49-57-0012 or 49-57-0013 on Milwaukee's 4292-1 or 4297-1 magnetic drill press or arbor 49-57-0032 on Milwaukee's 4262-1 mag press.
Milwaukee® 49-57-1000 Annular Cutter, 1 in Dia Cutter, 2 in D Cutting, Uncoated, Threaded Shank
Drill holes up to 3X faster than twist drill bits with the Milwaukee® 1 in. threaded Steel Hawg® cutter. This long-lasting cutter features Carbide teeth and an alternating cutting pattern to cut up to a 2 in. hole depth in steel, stainless steel, cast iron or aluminum. The spring-loaded, self-ejecting pin lets you make smoother, more accurate cuts and eject the plug faster. The Steel Hawg cutter works with most electromagnetic drill presses. Use it with arbor 49-57-0030 on Milwaukee's 4262-1 magnetic drill press or arbor 49-57-0010 on Milwaukee's 4292-1 mag press. The 1 in. bit diameter has a metric thread size of M18 x 1.5 in. shank. Use the threaded Steel Hawg with a No. 3 Morse taper arbor assembly 49 to 57 - 0010.
