1-1/2-SS-E-WELD 1-1/2" Stainless Steel 90 Degree
1-1/2" STAINLESS STEEL 90 DEGREE WELD ELBOW-FIT11/2SSEWELD >
Recently Viewed
1-1/2" STAINLESS STEEL 90 DEGREE WELD ELBOW-FIT11/2SSEWELD >
Browning® 3748878 Taper Lock Bushing, 3/4 in Dia Bore, 2-1/4 in Dia Barrel, 1 in OAL, Steel
Shaft support blocks are used for end or intermittent support where loads are light and deflection between supports is not a problem. Unlike shaft support rails, blocks do not permit longitudinal passage of open-type Ball Bushing® bearings. Type SB shaft support blocks enable clamping of shafts and eliminate the need for bolts, to maintain shaft position. Shimming is suggested for high-precision applications to eliminate the effect of variations in surface of base or manufacturing tolerances between supports.
MORSE® 58032 5944 Center Cutting Regular Length Single End End Mill, 1/2 in Dia Cutter, 1 in Length of Cut, 2 Flutes, 1/2 in Dia Shank, 3 in OAL, Bright
Make quick work of assembly applications with the FLEXDRIVE 14 pc. Cordless Screwdriver Set. The screwdriver features a compact design that conveniently fits in your tool pouch, with FLEXDRIVE 360 degree collar for seamless slide-to-drive control. With 6-stage torque adjustment and a rechargeable 2Ah integral battery, the FLEXDRIVE Cordless Screwdriver delivers up to 680 machine screws per charge*.
Browning® 1045517 VP Series Type 2 Variable Pitch Sheave, 1-1/8 in Finished Bore, 5.35 in OD, 1 Groove, 3.9 to 4.7 in (3L)/4.2 to 5.2 in (A/4L)/4.4 to 5.4 in (B/5L) Dia Pitch, 3/4 to 1-1/8 in W Face
The principle of a variable pitch sheave is that the threaded angular faced discs forming the V-shaped groove in which the belt rides are movable. VP sheaves consist of a male with a threaded barrel, and a female with a threaded bore. The male section with threaded barrel has flat surfaces at 180 deg increments that allow a flat surface for the setscrew to mate with. When the discs are moved toward each other, the belt rides higher in the groove and the pitch diameter of the sheave is larger which increases the driven speed. When the discs are moved away from each other, the belt rides lower and the pitch diameter is smaller decreasing the driven speed. The common term for this speed adjustment is called number of turns open from closed position.
