Dixon® MAH6 Miniature Worm Gear Clamp, 28/64 to 50/64 in Clamp, Stainless Steel Band, Stainless Steel Bolt, Domestic
Dixon® MAH6 Miniature Worm Gear Clamp, 28/64 to 50/64 in Clamp, Stainless Steel Band, Stainless Steel Bolt, Domestic
-
BrandDixon®
-
Manufacturer Part NumberMAH6
-
CountryUSA
-
Clamping Range28/64 to 50/64 in
-
Torque Rating15 in-lb
-
TypeMiniature
-
Grade300
-
Width5/16 in
-
SeriesMAH
-
Band MaterialStainless Steel
-
Domestic/ImportDomestic
-
Bolt MaterialStainless Steel Screw
-
Bolt Size1/4 in
- 1/4 in slotted hex head screw design
- SAE 300 series stainless steel
- Maximum recommended torque is 15 in. lbs
- Torque ratings correspond to the torque rating of the screw of the clamp and are not an indication of the working pressure of any hose assembly installed with this clamp
- Wash hands after handling
| Competitor Name | Competitor Part Number |
|---|---|
| Grainger | 58DF57 |
-
UNSPSC31162906
-
Package Description10/BX
-
Standards/ApprovalsSAE J1508
-
WarrantyLimited
-
Specification Sheet
-
Catalog
Recently Viewed
Dixon® MAH6 Miniature Worm Gear Clamp, 28/64 to 50/64 in Clamp, Stainless Steel Band, Stainless Steel Bolt, Domestic
Dixon® MAH6 Miniature Worm Gear Clamp, 28/64 to 50/64 in Clamp, Stainless Steel Band, Stainless Steel Bolt, Domestic
Carlon® E998E Service Entrance Cap, 3/4 in, 0.45 in Hole, For Use With SCH 40 and SCH 80 Rigid Non-Metallic Conduit, PVC
Carlon® E998E Service Entrance Cap, 3/4 in, 0.45 in Hole, For Use With SCH 40 and SCH 80 Rigid Non-Metallic Conduit, PVC
HCI Preferred Supplier 20808 Union Elbow, 12 mm Nominal, Push-In End Style, Brass
HCI Preferred Supplier 20808 Union Elbow, 12 mm Nominal, Push-In End Style, Brass
HCI Preferred Supplier 20807N 90 deg Union Elbow, 10 mm Nominal, Push-In End Style, Brass
HCI Preferred Supplier 20807N 90 deg Union Elbow, 10 mm Nominal, Push-In End Style, Brass
3/4" FEMALE HOSE THREADX3/4" FEMALE PIPE THREAD-JWH427187 >
John Guest® Speedfit® PEI0228 Union Tee, 3/4 in Nominal, CTS End Style, Plastic, Domestic
Push-fit plastic fitting for the connection of plastic, copper, and CPVC pipe. Designed, manufactured and assembled by John Guest Speedfit. Simply push the fitting fully onto the pipe and twist the plastic nut clockwise to lock in place. Should the need arise to demount the connection unlock the nut and push the collet towards the body of the fitting and pull the pipe to release. The fitting ensures an easier working environment in confined places, is approved for behind the wall installations, and removes the need for hot works on site. Installation can be reduced by around 40% when compared to traditional fixing methods.
