40213 MILWAUKEE HAND TRUCKS
24" X 42" STEEL PLATFORM TRUCK - GLE40213>
Recently Viewed
24" X 42" STEEL PLATFORM TRUCK - GLE40213>
Voltec 04-00102 3-Outlet In-Line Type STW GFCI Adapter With Lighted Power Block, 120 V, 12/3 AWG, 3 ft L
Voltec Power and Lighting has a full line of portable GFCI adapters, including right angle and in-line configurations, to fit every application. Choose from both 15 A u-ground and 20 A locking configurations. GFCI's protect the user from an electrical shock resulting from an unequal flow of electricity caused by current leakage. The occupational safety and health administration (OSHA) regulations state it is the employer's responsibility to provide GFCI's on all 120 V, 1-phase, 15/20 A receptacles on job sites that are not part of the permanent wiring of the structure.
2 -FEMALE PIPE THREAD GALVANIZED FLOOR FLANGES
2.5" -DIA 100-MESH.0045" STAINLESS STEEL SCREEN-JOH247171 >
IKO LRB242816 Inch Series Inner Ring With Oil Groove, 1-1/2 in ID x 1-3/4 in OD, 25.65 mm OAW, For Use With BR283716 Machined Type Needle Roller Bearing, High Carbon Steel
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Inch-type LRB series Inner Rings offer shaft diameters from 3/8 to 3-3/4 in and oil-hole versions for easier lubrication.
Martin 40BS16 5/8 Bored-to-Size Type BS Single Pitch Roller Chain Sprocket With Keyway, 5/8 in Dia Bore, 2.814 in OD, #40 Chain, 16 Teeth, 1/2 in Pitch, Steel
These finished bore sprockets are shaft ready and come complete with keyways and setscrews. The keyways are on center line of the tooth. Bored to size sprockets with 1/2 in bores and smaller are stocked with (2) setscrews only.
