Thomson LINEAR BEARING PILLOW BLOCK UNITS THP PB-12-A
Precision Steel Ball Bushing® bearings offer great improvements in efficiency, productivity and accuracy over high-friction plain bearings flat-ways. The all-steel design makes the bearing product line perfect for replacing plain bearings in high temperature applications. Rigid construction makes them very durable compared to ball bushing bearings with polymer components. When installed in a standard Thomson® pillow block, the Precision Steel Ball Bushing® bearing can self-align up to 3 deg in all directions.
-
BrandThomson®
-
UPC662486101055
-
Manufacturer Part NumberPB12A
-
CountryUSA
-
Load Capacity200 lb Dynamic
-
Temperature Rating185 deg F
-
TypeClosed Standard
-
Height2.13 in
-
Width2.06 in
-
SeriesPB Series
-
Shaft Diameter3/4 in
-
Bearing MaterialSteel
-
Outside Diameter2-3/4 in
-
Length2-3/4 in
- The round rail advantage which minimizes installation time and cost
- Steady state travel speeds up to 10 ft/s and accelerations to 450 ft/sq-s without the use of derating factors
- Replace high-friction plain bearings
- Lasting precision alignment
- High travel speeds
- Ease of installation
- Protection from contamination
- Closed pillow blocks are for end supported shafting
- For class S shafting
- Self-aligning
- Integral seals both ends
-
UNSPSC31171504
-
Package Description1/PK
-
Catalog
Recently Viewed
Thomson LINEAR BEARING PILLOW BLOCK UNITS THP PB-12-A
Precision Steel Ball Bushing® bearings offer great improvements in efficiency, productivity and accuracy over high-friction plain bearings flat-ways. The all-steel design makes the bearing product line perfect for replacing plain bearings in high temperature applications. Rigid construction makes them very durable compared to ball bushing bearings with polymer components. When installed in a standard Thomson® pillow block, the Precision Steel Ball Bushing® bearing can self-align up to 3 deg in all directions.
Drillco 24A120C6 2400 General Purpose Pulley Tap, 5/16-18 Thread
Pulley taps are used for tapping the hubs of pulleys for oil caps or set screws. The long shank is also ideal for reaching holes inaccessible with standard length taps. The thread length is the same length as a standard tap.
Porter-Cable® 9543 Jig Saw, 120 VAC, For Blade Shank: T-Shank, 10-1/4 in OAL
ASP-150-2-SSS Industry Standard Clamping Collar, 2-Piece Construction, 1-1/2 in ID x 2-3/8 in OD x 9/16 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
NIBCO® 852-020 1-Piece Solid Flange, 2 in Nominal, PVC, Thread Connection, 150 lb, 6 in OD, Domestic
NIBCO® 852-020 1-Piece Solid Flange, 2 in Nominal, PVC, Thread Connection, 150 lb, 6 in OD, Domestic
NIBCO® 852-025 1-Piece Solid Flange, 2-1/2 in Nominal, PVC, Thread Connection, 150 lb, 7-1/16 in OD, Domestic
NIBCO® 852-025 1-Piece Solid Flange, 2-1/2 in Nominal, PVC, Thread Connection, 150 lb, 7-1/16 in OD, Domestic
