222-638 NATIONAL HARDWARE PRODUCTS
1" BOLT SNAPS-NTL222638 >
Recently Viewed
1" BOLT SNAPS-NTL222638 >
1" GALVANIZED MALLEABLE WIREROPE CLAMPS-SWC3MC0012 >
MORSE® 42084 1881 Center Cutting Long Length Single End End Mill, 1/2 in Dia Cutter, 2 in Length of Cut, 3 Flutes, 1/2 in Dia Shank, 4 in OAL, Bright
FHP V-BELT-JAS5L610 >
TIMING BELTS-JAS165L100>
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
