Gardner Bender GHG-1575 Flexible Grommet, 3/4 in ID, Vinyl
This grommets helps protect wire and cable from sharp metal edges as well as eliminating the risk of wire, cord or hose chaffing on applications due to metal drill holes or cutouts. Each rubber grommet is flexible and enables simple installation by easily snapping the rubber grommet directly into the drill hole. The rubber grommets ensure your wiring projects and applications are sustainable and protected.
-
BrandGardner Bender
-
UPC032076898311
-
Manufacturer Part NumberGHG-1575
-
CountryUSA
-
MaterialVinyl
-
ColorBlack
-
TypeFlexible
-
Diameter3/4 in ID
- Snap into holes in steel boxes and sheeting
- Protect cable insulation from damage
- Flexible vinyl construction
-
UNSPSC31162401
-
Package DescriptionEACH
-
Warranty1 year
-
Catalog
Recently Viewed
This grommets helps protect wire and cable from sharp metal edges as well as eliminating the risk of wire, cord or hose chaffing on applications due to metal drill holes or cutouts. Each rubber grommet is flexible and enables simple installation by easily snapping the rubber grommet directly into the drill hole. The rubber grommets ensure your wiring projects and applications are sustainable and protected.
#14 X 1/2" Pan Head Combo Sheet Metal Screws
1/4" -FEMALE PIPE THREADX1/4" -FEMALE PIPE THREAD HYDRAULIC COUPLING-DAY500044 >
Pyramex® SB2830S Fully Adjustable Safety Eyewear, Anti-Scratch, Amber Lens, Black, Polycarbonate Frame, ANSI Z87.1, CE EN166, MIL-PRF 32432
DRILLCO 440N512 Type B Heavy Duty Jobber Length Drill Bit, L Drill - Letter, 0.29 in Drill - Decimal Inch, 135 deg Point, HSS, Oxide Treated
Nitro® drills (NAS Type B) offer superior performance over standard HSS drills. Heavy-duty design increases tool life and performance. 135° Split Point reduces walking at the point. Ideal for both hand held and CNC Operations. Black & Gold.
Koyo TRC-2233 Double Direction Thrust Washer, 34.93 mm ID x 52.37 mm OD, 2.41 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
