G-429-5/8 CROSBY 9/16"-5/8" FIST CABLECLAMP
Fist Grip® wire rope clips from Crosby® differ from traditional wire rope clips, with bolts and heavy hex nuts comprising the design. This allows for the nuts to be installed in a way that lets the operator swing the wrench in a full arc for quick install. Saddles are forged steel, with the entire clip galvanized for corrosion resistance.
Provides an efficiency rating of 80% for sizes 3/16" - 7/8", and 90% for sizes 1" - 1-1/2". All sizes meet or exceed all requirements of ASME B30.26 including identification, ductility, design factor, proof load and temperature requirements. All sizes also meet additional critical performance requirements including fatigue life, impact properties and material traceability, not address by ASME B30.26.
Recently Viewed
Fist Grip® wire rope clips from Crosby® differ from traditional wire rope clips, with bolts and heavy hex nuts comprising the design. This allows for the nuts to be installed in a way that lets the operator swing the wrench in a full arc for quick install. Saddles are forged steel, with the entire clip galvanized for corrosion resistance.
Provides an efficiency rating of 80% for sizes 3/16" - 7/8", and 90% for sizes 1" - 1-1/2". All sizes meet or exceed all requirements of ASME B30.26 including identification, ductility, design factor, proof load and temperature requirements. All sizes also meet additional critical performance requirements including fatigue life, impact properties and material traceability, not address by ASME B30.26.
Milton s680 30" Swivel end snubber hoses with a 3/8" ID and 1/4" NPT Swivel. Use snubber hoses to absorb shock to air couplers from percussion type tools. Snubber hoses are fitted with a full 360 degree swivel for greater flexibility and easy use.
30 in swivel end Snubber Hoses with a 3/8 in ID and 1/4 in NPT swivel. Use Snubber Hoses to absorb shock to air couplers from percussion type tools. Snubber Hoses are fitted with a full 360 deg swivel for greater flexibility and easy use.
Installed at floor level to allow water to flow into your sewage drainage system.
Browning® 767315 VPLE 100 Intermediate Duty Low Base Pillow Block Ball Bearing Unit, 1-3/8 in Dia Bore, 4-9/16 to 5-7/16 in L Bolt Center-to-Center, 1-13/16 in Base to Bore Centerline, 6-3/4 in OAL x 3-5/8 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric or BOA concentric locking collar. The contact seal with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction.
Keeney 270WK S-Trap, 1-1/4 in Inlet x 1-1/4 in Outlet, Polypropylene, Slip Joint Connection
Keeney 270WK S-Trap, 1-1/4 in Inlet x 1-1/4 in Outlet, Polypropylene, Slip Joint Connection
YR-2-1/4-X 2-1/4" Sealed Yoke Cam Follower
2-1/4" SEALED YOKE CAM FOLLOWER - SMIYR21/4X>
