Proto Tools 7"-LONG STRAIGHT-JAW LOCKING PLIER PRO J-291-R
Proto® J291R Locking Plier, 1-1/8 in, 1/2 in THK Straight Alloy Steel Jaw
-
BrandProto®
-
UPC662679031480
-
Manufacturer Part NumberJ291R
-
CountryUSA
-
Handle TypeTrigger Release
-
Nominal Capacity1-1/8 in
-
Cutter IncludedNo
-
Specifications MetASME B107.24
-
Jaw MaterialAlloy Steel
-
Jaw Size1/2 in THK
-
Jaw TypeStraight
-
Overall Length7 in
- Straight jaws allow for maximum contact on flat, square or hex work
- Heat treated alloy steel for maximum toughness and durability
- Adjusting screw provides precise pressure
- Guarded release trigger provides safety (against accidental opening) as well as quick release
-
UNSPSC27112115
-
Standards/ApprovalsASME B107.24
-
WarrantyLimited Lifetime
-
Catalog
Recently Viewed
Proto® J291R Locking Plier, 1-1/8 in, 1/2 in THK Straight Alloy Steel Jaw
1-1/2" X 1/2" STEEL BLACK BUSHINGS-JPW11/2X1/2FSBB>
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. The BMU bearings are commonly referred to as thrust bearings. These bearings have a 40 deg contact angle to accept heavy axial loads. The bearings have Universally Flush Ground rings to facilitate mounting in multiple bearing sets. The inner and outer rings have identical widths. These bearings can be mounted as DB, DF and DT pairs or can be combined into triplex and quadraplex sets. When two bearings are mounted together, a clearance or preload may be obtained without the use of shims or spacers. This bearing has a machined brass cage and is not available with seals or shields. These bearings are most commonly used in vertical pump and motor applications.
ASP-125-2-SSS Industry Standard Clamping Collar, 2-Piece Construction, 1-1/4 in ID x 2-1/16 in OD x 1/2 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
Chicago Hardware 12988-6 Shoulder Pattern Threaded Machinery Eye Bolt, 1-8, 2-1/2 in L Shank, Heat Treated Drop Forged Steel
ipg® 83689 AC15 Utility-Grade Duct Tape, 54.8 m L x 48 mm W, 0.2 mm THK, Latex Adhesive, Polyethylene Backing, Silver/Black
Ipg® offers a full range of cloth duct tape to satisfy even the most demanding requirements and industry standards. From utility grade to premium grade HVAC duct tapes, all Intertape® brand tapes are manufactured with high grade raw materials and held to the highest quality standards. Choose from standard silver and black duct tape to a variety of colors and grades for heavy industrial use, HVAC and plumbing, tough construction jobs, hanging poly sheeting, bundling, wrapping, sealing and general purpose.

