Eklind® 15907 Star End Torx Key, Torx® Drive, L-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
Eklind® 15907 Star End Torx Key, Torx® Drive, L-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
-
BrandEklind®
-
UPC037516159076
-
Manufacturer Part Number15907
-
CountryUSA
-
FinishBlack Oxide
-
MaterialAlloy Steel
-
Tip SizeT7
-
Measurement SystemTorx®
-
TypeStar End
-
Handle TypeL-Handle
-
Arm Length3.05 in
-
Arm TypeLong
-
Working Angle35 deg
-
Specifications MetANSI B18.3
-
Blade MaterialAlloy Steel
-
Drive TypeTorx®
- High quality, industrial grade professional tools made in the USA
- 3.05 in long arm/0.61 in short arm
- These Eklind® tools are made with Eklind® alloy steel that is heat treated, quenched and tempered for optimum strength, torque and ductility for safety and coated with a rust resistant finish
- Drive Torx®, Torx Plus® and star socket recess fasteners and meet all applicable standards set by the registered trademark holder, Acument Intellectual Properties, LLC
-
UNSPSC27111716
-
Package Description1/PK
-
Standards/ApprovalsANSI Specified|ASME Specified|Dodd-Frank Conflict Minerals Legislation|Federal Specification GGG-K-275D|RoHS Compliant|REACH Compliant|PROP65: Cancer and Reproductive Harm - www.P65warnings.ca.gov
-
Catalog
Recently Viewed
Eklind® 15907 Star End Torx Key, Torx® Drive, L-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
Eklind® 15907 Star End Torx Key, Torx® Drive, L-Handle Handle, ANSI B18.3, Alloy Steel, Black Oxide
MULTI-PURPOSE OSCILLATING TOOL KIT - JWH363261>
174" BANDSAW BLADE-MORZWEG083R1014'6">
Dixon® DMH2015F Hex Nipple, 2 x 1-1/2 in Nominal, MNPT x Male NST, Cast Brass, Domestic
Dixon® DMH2015F Hex Nipple, 2 x 1-1/2 in Nominal, MNPT x Male NST, Cast Brass, Domestic
1/2" X 2-1/2" Square Head Set Screw
Koyo IR-88 Inch Series Regular Width Inner Ring, 1/2 in ID x 3/4 in OD, 0.515 in OAW, For Use With B-126, B-128, J-126, J-128, M-1261, M-1281 Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
