Spiral Bevel Right Angle Drives
Browning® cast iron bevel and spiral bevel gear reducers are constructed of rugged cast iron housings. These housings are line bored for precise gear and bearing alignment. To offer maximum performance, these reducers are designed with tapered roller and ball bearings. Browning® cast iron bevel and spiral bevel gear reducers are available in six sizes and ratios. These range from 1:1 to 3:1, with speed-up ratios available. Torque capacity ranges from 99 to 5942 in-lb.
Browning® cast iron bevel and spiral bevel gear reducers are constructed of rugged cast iron housings. These housings are line bored for precise gear and bearing alignment. To offer maximum performance, these reducers are designed with tapered roller and ball bearings. Browning® cast iron bevel and spiral bevel gear reducers are available in six sizes and ratios. These range from 1:1 to 3:1, with speed-up ratios available. Torque capacity ranges from 99 to 5942 in-lb.
Recently Viewed
24-OZ DEAD BLOW BALL PEIN HAMMER -ARS68524 >
RIDGID® 31705 Coil and Flat Spring Assembly, For Use With 24 in Straight Pipe Wrench
RIDGID® 31705 Coil and Flat Spring Assembly, For Use With 24 in Straight Pipe Wrench
607-008-0150 8-32" X 1-1/2" USS Stainless Steel Flat Head Socket Head Capscrew
8-32" X 1-1/2" USS Stainless Steel Flat Head Socket Head Capscrew
Milwaukee® 48-25-1122 Standard Drill Bit, 1-1/8 in Dia, 6 in OAL, 7/16 in Shank
Milwaukee® Selfeed drill bits deliver speed and endurance for repetitive drilling of large holes. Designed for any trade that demands woodcutting for installing pipe and conduit, Selfeed bits feed into work without pressure and provide faster boring of clean, accurate holes. The bits have improved balance with reduced runout, while the hex shank provides a secure gripping surface for the drill chuck. Every Milwaukee Selfeed drill bit is coated with a rust inhibitor. Built to last and designed to perform, these Selfeed bits are resharpenable so you can keep them cutting like new. Two feed screws are included.
3/4" -MALE PIPE THREADX48 REDI-CUT GALVANIZED PIPE NIPPLE. BOTH ENDS THREADED AND WITH THREAD PROTECTOR-JWH424366 >
3/8" X 3/4" USS SOCKET SET SCREWS-NBS7190380075 >
