Dichtomatik N90129 O-Ring, 129 Dash Number, 1.549 in ID x 1.755 in OD, Nitrile Rubber, 90 Shore A Durometer, Import, Custom 129-BUNA-90
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberN90129
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter1.549 in
-
Domestic/ImportImport
-
Durometer90 Shore A
-
Outside Diameter1.755 in
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Specification Sheet
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Drillco 675A148D 6750A Center Cutting Imperial Long Length Single End Finishing End Mill, 3/4 in Dia Cutter, 3/4 in Length of Cut, 4 Flutes, 3/4 in Dia Shank, 3 in OAL, Uncoated
The greater red hardness of M-42 Cobalt end mills enables these tools to run about 10% faster than conventional HSS end mills. This translates to shorter machining times and permits higher utilization of available machine horsepower.
DECKER HUMP HILL'S RINGS--PIG, SHOAT, AND HOG SIZES ARE MADE WITH A SLIGHT BEND OR HUMP IN THE CENTER SO THEY CLOSE EASILY. MADE OF DURABLE COPPER-COATED STEEL.
-JWH714766 >
MORSE® 58158 5955 Center Cutting Long Length Single End End Mill, 7/16 in Dia Cutter, 2 in Length of Cut, 4 Flutes, 7/16 in Dia Shank, 4 in OAL, Bright
DOUBLE SHIELDED BALL BEARING WITH SNAP RING-GUL63072ZNR >
GRAY SAFETY GLASSES LENS-SSSL19902>
