Dichtomatik S70115 O-Ring, 115 Dash Number, 0.674 in ID x 0.88 in OD, Silicone Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberS70115
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialSilicone Rubber
-
ColorRed
-
Inside Diameter0.674 in
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter0.88 in
- Good chemical stability in water (up to 100 deg C), aliphatic engine and transmission oils, animal and plant based oils and greases
- Not resistant to fuels, aromatic mineral oils, water vapor (short periods up to a maximum of 120 deg C are possible), silicone oils and greases, along with acids and alkaline compounds
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik S70115 O-Ring, 115 Dash Number, 0.674 in ID x 0.88 in OD, Silicone Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Greenlee’s High Performance and Double Braided cable pulling rope offer both strength and durability. Select a rope with a maximum rated capacity that meets or exceeds the tugger's maximum pulling force.
Sure-Grip® quick detachable bushings are easy to install and remove. Split-through flange and taper provide a true clamp on the shaft that is equivalent to a shrink fit. All sizes except JA and QT have a set screw over the key to help maintain the bushing's position on the shaft until the cap screws are securely tightened. Versatile Sure-Grip® bushings permit the mounting of the same mating part on shafts of different diameters and the mounting of different sheaves on the same shaft using the same bushing.
Dodge® 123821 211 Normal Duty Pillow Block Ball Bearing Unit, 2-1/4 in Dia Bore, 6.38 to 7.44 in L Bolt Center-to-Center, 2-1/2 in Base to Bore Centerline, 8.88 in OAL x 4.96 in OAH
Dodge® 123821 211 Normal Duty Pillow Block Ball Bearing Unit, 2-1/4 in Dia Bore, 6.38 to 7.44 in L Bolt Center-to-Center, 2-1/2 in Base to Bore Centerline, 8.88 in OAL x 4.96 in OAH
Morse® 131582 MHSTK Hole Saw, 3-5/8 in Dia, 1-15/16 in D Cutting, Carbide Cutting Edge, 5/8 to 18 Arbor
1" - 8" ALLEN NUT-HOL06058 >
