Dichtomatik 67004475 O-Ring, 65 mm ID x 73 mm OD, Nitrile Rubber, 70 Shore A Durometer, Domestic
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number67004475
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter65 mm
-
Domestic/ImportDomestic
-
Durometer70 Shore A
-
Outside Diameter73 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberN4.00X065
-
Specification Sheet
-
Catalog
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik 67004475 O-Ring, 65 mm ID x 73 mm OD, Nitrile Rubber, 70 Shore A Durometer, Domestic
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Dichtomatik 67188388 O-Ring, 3 mm ID x 7 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2 X 3
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
MORSE® 42084 1881 Center Cutting Long Length Single End End Mill, 1/2 in Dia Cutter, 2 in Length of Cut, 3 Flutes, 1/2 in Dia Shank, 4 in OAL, Bright
400-WATT CLEAR MERCURY BULBS-BULH33CD400 >
HCI Preferred Supplier 38094 90 deg Tube-to-Pipe Elbow, 3/8 x 1/8 in Nominal, Nylon AB x Male NPTF End Style, CA360 Brass
HCI Preferred Supplier 38094 90 deg Tube-to-Pipe Elbow, 3/8 x 1/8 in Nominal, Nylon AB x Male NPTF End Style, CA360 Brass
30" PLASTIC EASY LEAF BAGGER-JWH716847 >
