Dichtomatik 67196491 O-Ring, 56 mm ID x 64 mm OD, FKM, 80 Shore A Durometer, Import
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number67196491
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter56 mm
-
Domestic/ImportImport
-
Durometer80 Shore A
-
Outside Diameter64 mm
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberV4.00X056
-
Specification Sheet
-
Instruction/Installation Manual
-
Catalog
Recently Viewed
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
Proto® J406A Regular Duty C-Clamp, 3-5/8 in D Throat, 6 in Jaw Opening
Inner Rings can be integrated with shell-type or various machined needle roller bearings to provide good roller support without worrying about premature shaft wear. We heat-treat and grind our Inner Rings to tight tolerances to create hard, tough raceways for applications where it is impossible to make shaft surfaces to a specific hardness or roughness attribute. They're an economical alternative to bushings because they don't require any additional machining. Wide Inner Rings are also available to accommodate shafts that move axially or seals that are adjacent to bearings. Inner Rings come in a broad range of shaft diameters and assembly elements include small chamfers or gentle taper relief options. Inner Rings for machined-type needle roller bearings come in a variety of dimensions. Inch-type LRB series Inner Rings offer shaft diameters from 3/8 to 3-3/4 in and oil-hole versions for easier lubrication.
FYH® SA207 23FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-7/16 in Dia Bore, 1.26 in W, 25.7 kN Dynamic/15.4 kN Static Load
FYH® SA207 23FP9 SA Series Narrow Inner Ring Bearing Pillow Block Unit, 1-7/16 in Dia Bore, 1.26 in W, 25.7 kN Dynamic/15.4 kN Static Load
1/2" X 1-3/4" MD RECT DIE SPRINGS-LANSMDR500175 >
3000/PSI 2-1/2" -FACE 1/4" NATIONAL PIPE THREAD GAUGE-DXNGL370 >
