Dichtomatik 75189232 O-Ring, 47 mm ID x 52 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 47
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number75189232
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter47 mm
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter52 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberN2.50X047
-
Catalog
-
Instruction/Installation Manual
-
Specification Sheet
Recently Viewed
Dichtomatik 75189232 O-Ring, 47 mm ID x 52 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 47
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
1.5" EMT CONDUIT SETSCREW COUPLING-ELEL130 >
#22-18 NYLON RING TERMINALPK/100-PENR6A56C>
1/2" 2000-PSI STEEL/HYD BALL VALVE-NIBT560CSR251/2 >
Gates® Power Transmission Hi-Power® II BB133 Banded Heavy Duty Double V-Belt, BB Section, 21/32 in W Top, 136 in L Outside, 17/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
Channellock® 356 Non-Insulated Standard End Cutting Plier, 0.056 to 0.091 in Piano Wire Cutting, 0.35 in, 6-1/4 in OAL, Plastic Handle
CHANNELLOCK® High Leverage End Cutting Pliers feature Xtreme Leverage Technology (XLT™) which makes cutting easier than ever. By positioning the rivet closer to the cutting edge, considerably less force is required to cut than other high leverage designs. State-of-the-art laser heat treating offers a strong and consistent pattern across the cutting edge for increased strength and longevity. These pliers also offer a slimmer, lighter, and better-balanced design for maximum performance and accessibility. CHANNELLOCK® End Cutting Pliers are made in USA and forged from high carbon U.S. steel that is specially coated for ultimate rust prevention.
