Dichtomatik 67013594 O-Ring, 180 mm ID x 190 mm OD, FKM, 80 Shore A Durometer, Import
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
-
BrandDichtomatik
-
Manufacturer Part Number67013594
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialFKM
-
ColorBlack
-
Inside Diameter180 mm
-
Domestic/ImportImport
-
Durometer80 Shore A
-
Outside Diameter190 mm
- Good chemical resistance to mineral oils and greases, synthetic oils and greases, motor, transmission and ATF oils up to 150 deg C
- Very good weathering, ozone and aging resistance
- Very low gas permeability
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberV5.00X180
-
Catalog
-
Specification Sheet
-
Instruction/Installation Manual
Recently Viewed
Dichtomatik 67013594 O-Ring, 180 mm ID x 190 mm OD, FKM, 80 Shore A Durometer, Import
O-rings are endless, ring shaped sealing elements with a circular cross-section that are manufactured from elastomer materials or PTFE. The designation of an O-ring is derived from the dimensions of its inner diameter and cord width in millimeters, along with the name of the material and its Shore A hardness.
5/8" METAL STRAP OPEN SEAL-DUB5/8S >
1-1/4" -IDX1-3/8" -OD VITON O-RING-CUS026VITON >
DeWALT® DG5103 Small Maintenance Electrician's Pouch, For Use With Tool Storage, 20 (Small)/9 (Main) Pockets, Ballistic Poly Fabric
The DeWALT® small maintenance electrician's pouch has a large main pocket and smaller pockets and sleeves for organizing your favorite tools and can attach to your belt via a traditional sleeve or available metal clip.
Dichtomatik N70151 O-Ring, 151 Dash Number, 2.987 in ID x 3.193 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
1-1/4" X 3" USS Eyebolts With Shoulders
