Dichtomatik N2.50X016 O-Ring, 16 mm ID x 21 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 16
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part NumberN2.50X016
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter16 mm
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter21 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Instruction/Installation Manual
-
Specification Sheet
-
Catalog
Recently Viewed
Dichtomatik N2.50X016 O-Ring, 16 mm ID x 21 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-2.5 X 16
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
23-TOOTH #60-1 CHAIN SPROCKETS IDC 60-B-23-F1-15/16
23 TOOTH SPROCKETS FOR #60 CHAIN
XL-PITCHX43" TIMING BELTS-SCI430XL037 >
Browning® 767855 VPLE 200 Normal Duty Pillow Block Ball Bearing, 1-3/8 in Dia Bore, 4-5/8 to 5-3/8 in L Bolt Center-to-Center, 1-13/16 in Base to Bore Centerline, 6-3/4 in OAL x 3-5/8 in OAH
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric, or BOA concentric locking collar. The contact seal, with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction. Depending on your preference, these bearings are available in inch and metric bore with a wide variety of cast iron, stamped steel or rubber mount housings or specific industry solutions as illustrated on the pages to follow.
TAPERED ROLLER BEARING CONE-NTN55206C >
10-MM-PITCH X 500-MM TIMING BELT - JAS16T10/500 >
