Dichtomatik 75138246 O-Ring, 116 mm ID x 122 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-3 x 116
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
-
BrandDichtomatik
-
Manufacturer Part Number75138246
-
CountryUSA
-
Temperature Rating40 to 120 deg F
-
MaterialNitrile Rubber
-
ColorBlack
-
Inside Diameter116 mm
-
Domestic/ImportImport
-
Durometer70 Shore A
-
Outside Diameter122 mm
- Good chemical resistance to mineral oils and greases
-
UNSPSC31401503
-
Standards/ApprovalsDNV Approved|FDA Compliant|ISD Certified|NFPA Listed|PTDA Certified
-
Alternative Part NumberN3.00X116
-
Instruction/Installation Manual
-
Specification Sheet
-
Catalog
Recently Viewed
Dichtomatik 75138246 O-Ring, 116 mm ID x 122 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import, Custom H-3 x 116
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Dichtomatik 75125853 O-Ring, 30 mm ID x 36 mm OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
MORSE® 43670 1898 Center Cutting Regular Length Single End End Mill, 7/8 in Dia Cutter, 1-1/2 in Length of Cut, 2 Flutes, 3/4 in Dia Shank, 3-3/4 in OAL, Bright
MARXMANâ„¢ 88137 189 Center Cutting Regular Length Single End End Mill, 5/32 in Dia Cutter, 7/16 in Length of Cut, 2 Flutes, 3/8 in Dia Shank, 2-5/16 in OAL, Bright
