7/8" X 8" SAE GR-5 Hex Head Capscrew
7/8" X 8" SAE GR-5 Hex Head Capscrew
-
BrandGeneric
-
Manufacturer Part NumberNBS1060870800
Recently Viewed
7/8" X 8" SAE GR-5 Hex Head Capscrew
7/8" X 6" USS GR-8 Hex Head Capscrew
BBI 486326 Lag Bolt, 3/8-7, 2 in OAL, Low Carbon Steel, Zinc Plated (CR+3)
BBI 588447 Fully Threaded Machine Screw, #10-24, 1-1/2 in OAL, Round Head, Zinc CR+3 Plated, Phillips® Drive
BBI 588447 Fully Threaded Machine Screw, #10-24, 1-1/2 in OAL, Round Head, Zinc CR+3 Plated, Phillips® Drive
5/32" X 2-1/2" Cotter Pins
Koyo TRB-2435 Double Direction Thrust Washer, 38.1 mm ID x 55.55 mm OD, 1.6 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
