BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
-
BrandBBI
-
Manufacturer Part Number042650
-
CountryUSA
-
FinishZinc Yellow Bake CR+6
-
Tensile Strength150000 psi
-
MaterialAlloy Steel
-
Thread TypeUNF
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade8
-
Hardness33 to 39 HRC
-
Head Size35/64 in H
-
Head TypeHex
-
Shank Size7/8 in
-
Diameter - Thread Size7/8-14
-
Length Under Head8 in
-
UNSPSC31161501
-
Package Description10/CS
Recently Viewed
BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
Flex-Hone® BC5832 BC Series Small Diameter Standard Duty Flexible Cylinder Hone, 5/8 in Dia Bore, 2-1/2 in L Abrasive, 8 in OAL, 320 Grit
The BC Series Flex-Hone® tool is designed for use on any type or size of cylinder from 4 mm up to 3 in Dia. This cylinder hone is designed for surface finishing and cross hole deburring in brake cylinders, wheel cylinders, hydraulics, pneumatics and valve guides.
18/2" CLEAR LAMP CORD--250' ROLL-JWH548995 >
NACHI 7212B Angular Contact Ball Bearing, 60 mm Dia Bore, 110 mm OD, 1 Row, 22 mm W, 40 deg, 58000 N Dynamic/46000 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. A matching high shoulder is often on the opposite side of the inner ring as well. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. This ball bearing has a 40 deg contact angle. This bearing has a stamped steel cage and is not available with seals or shields. These bearings are non-separable. These bearings have normal tolerances and are not suitable for mounting adjacent to each other to achieve a preload.
Drillco 76A128C 7600 Center Cutting Imperial Regular Length Single End Ball Nose End Mill, 7/16 in Dia Cutter, 1 in Length of Cut, 2 Flutes, 7/16 in Dia Shank, 2-3/4 in OAL, Bright
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Ball nose.
POSTS/PANELS-HLW50941807TAN>
