BBI 847226 Partially Threaded Cap Screw, 7/16-14, 2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 847226 Partially Threaded Cap Screw, 7/16-14, 2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
-
BrandBBI
-
Manufacturer Part Number847226
-
CountryUSA
-
FinishZinc CR+3
-
Tensile Strength120000 psi
-
MaterialMedium Carbon Steel
-
Material SpecificationASTM B633
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade5
-
Hardness25 to 34 HRC
-
Head Size9/32 in H
-
Head TypeHex
-
Shank Size7/16 in
-
Diameter - Thread Size7/16-14
-
Length Under Head2 in
-
UNSPSC31161501
-
Package Description50/CS
-
Standards/ApprovalsASME B18.2.1
-
Catalog
Recently Viewed
BBI 847226 Partially Threaded Cap Screw, 7/16-14, 2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 847226 Partially Threaded Cap Screw, 7/16-14, 2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
Jacobs® 30251 T-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: K32, For Use With 3/8 in and 1/2 in Chucks, Soft Steel
Jacobs® 30251 T-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: K32, For Use With 3/8 in and 1/2 in Chucks, Soft Steel
Makita 763411-7A Heavy Duty Chuck Key, 1/2 in Chuck Key, For Use With 6013BR Hand Drill, Aluminum
Makita 763411-7A Heavy Duty Chuck Key, 1/2 in Chuck Key, For Use With 6013BR Hand Drill, Aluminum, Side Handle
Browning® 3748548 Taper Lock Bushing, 1 in Dia Bore, 1.511 in Dia Barrel, 7/8 in OAL, Steel
Koyo IR-2020 Inch Series Regular Width Inner Ring, 1-1/4 in ID x 1-1/2 in OD, 1.265 in OAW, For Use With B-268, B-2610, B-2616, J-2610, J-2616, M-26161, M-26101 Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
Jacobs® 3605 L-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: KGA, For Use With 1/4 in and 3/8 in Multi-Craft® Chucks, Soft Steel
Jacobs® 3605 L-Handle Chuck Key, 1/4 in Dia Pilot, Key Number: KGA, For Use With 1/4 in and 3/8 in Multi-Craft® Chucks, Soft Steel

