BBI 455084 Partially Threaded Cap Screw, 5/16-18, 1-3/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455084 Partially Threaded Cap Screw, 5/16-18, 1-3/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
-
BrandBBI
-
UPC662403339141
-
Manufacturer Part Number455084
-
CountryUSA
-
FinishZinc Yellow Bake CR+6
-
Tensile Strength150000 psi
-
MaterialAlloy Steel
-
Material SpecificationASTM B633-Fe, Zn5 Type 2
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade8
-
Hardness33 to 39 HRC
-
Head Size13/64 in H
-
Head TypeHex
-
Shank Size5/16 in
-
Diameter - Thread Size5/16-18
-
Length Under Head1-3/4 in
-
UNSPSC31161501
-
Package Description100/CS
-
Standards/ApprovalsASME/ANSI B18.2.1
Recently Viewed
BBI 455084 Partially Threaded Cap Screw, 5/16-18, 1-3/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455084 Partially Threaded Cap Screw, 5/16-18, 1-3/4 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
1-1/2" SASH PAINT BRUSH-JWH783156 >
Loctite® 234889 Flexible Cure Slow Dry Gasket Sealant, 1.5 oz Tube
Sealmaster 1-3/4"-ID 4-BOLT SPH FLANGE UNITS BRW SFC-1000-NE X 1-3/4
Sealmaster® USRB performance mounted spherical roller bearings feature black oxide treated bearing steel races with optimized bearing geometry for load capacity, misalignment and speed capabilities. The USRB is available in both setscrew locking and adapter mounting system. The felt seal with flinger provides a good balance between contaminant entry, grease retention and friction. Depending on application requirements, these bearings are available in a wide variety of bore sizes, housing styles and sealing options.
The DCB206 DEWALT 20V MAX 6.0Ah XR Battery provides immediate feedback on state of charge with the 3-LED Fuel Gauge System and has a lightweight design for easy transporting of DEWALT 20V MAX battery.
Koyo IR-2424 Inch Series Regular Width Inner Ring, 1-1/2 in ID x 1-3/4 in OD, 1.515 in OAW, For Use With Inch Series Drawn Cup Needle Roller Bearing, Steel
Where it becomes impractical to meet the shaft raceway design requirements (hardness, case depth, surface finish, etc.) outlined in the engineering section, standard inner rings for drawn cup bearings are available. Inner rings for drawn cup bearings are designed to be a loose transition fit on the shaft and should be clamped against a shoulder. If a tight transition fit must be used to keep the inner ring from rotating relative to the shaft, the inner ring OD as mounted, must not exceed the raceway diameters required by the drawn cup bearing for the particular application.
