BBI 042528 Partially Threaded Cap Screw, 3/4-10, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042528 Partially Threaded Cap Screw, 3/4-10, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
-
BrandBBI
-
UPC662403339615
-
Manufacturer Part Number042528
-
CountryUSA|Canada
-
FinishZinc Yellow Bake CR+6
-
Tensile Strength150000 psi
-
MaterialAlloy Steel
-
Material SpecificationASTM B633-Fe, Zn5 Type 2
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade8
-
Hardness33 to 39 HRC
-
Head Size15/32 in H
-
Head TypeHex
-
Shank Size3/4 in
-
Diameter - Thread Size3/4-10
-
Length Under Head5 in
-
UNSPSC31161501
-
Package Description25/CS
-
Standards/ApprovalsASME/ANSI B18.2.1
Recently Viewed
BBI 042528 Partially Threaded Cap Screw, 3/4-10, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042528 Partially Threaded Cap Screw, 3/4-10, 5 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
1/4" -MALE PIPE THREAD METAL BLACK PLUG-FIT1/4BP >
Morse® 177139 MHS Advanced Hole Saw, 13/16 in Dia, 1-15/16 in D Cutting, M42 HSS-Co 8 Cutting Edge, 1/2-20 Arbor
The all new advanced bi-metal hole saw by M.K. Morse®. Our latest sawing innovation replaces all current Morse bi-metal hole saw solutions into one, simple optimized powerhouse. Arbor required.
20-AMP FUSES-LITNLN20 >
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction.
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. A matching high shoulder is often on the opposite side of the inner ring as well. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. This ball bearing has a 40 deg contact angle. This bearing has a stamped steel cage and is not available with seals or shields. These bearings are non-separable. These bearings have normal tolerances and are not suitable for mounting adjacent to each other to achieve a preload.
