BBI 847672 Partially Threaded Cap Screw, 1-8, 3-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 847672 Partially Threaded Cap Screw, 1-8, 3-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
-
BrandBBI
-
Manufacturer Part Number847672
-
CountryUSA
-
FinishZinc CR+3
-
Tensile Strength120000 psi
-
MaterialMedium Carbon Steel
-
Material SpecificationASTM B633
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
Grade5
-
Hardness25 to 34 HRC
-
Head Size39/64 in H
-
Head TypeHex
-
Shank Size1 in
-
Diameter - Thread Size1-8
-
Length Under Head3-1/2 in
-
UNSPSC31161501
-
Package Description10/CS
-
Standards/ApprovalsASME B18.2.1
-
Catalog
Recently Viewed
BBI 847672 Partially Threaded Cap Screw, 1-8, 3-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
BBI 847672 Partially Threaded Cap Screw, 1-8, 3-1/2 in L Under Head, 5 Grade, Medium Carbon Steel, Zinc CR+3
9W MINI TWIST BULB (40W)-JWH504262 >
BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 042650 Partially Threaded Cap Screw, 7/8-14, 8 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
Flex-Hone® BC5832 BC Series Small Diameter Standard Duty Flexible Cylinder Hone, 5/8 in Dia Bore, 2-1/2 in L Abrasive, 8 in OAL, 320 Grit
The BC Series Flex-Hone® tool is designed for use on any type or size of cylinder from 4 mm up to 3 in Dia. This cylinder hone is designed for surface finishing and cross hole deburring in brake cylinders, wheel cylinders, hydraulics, pneumatics and valve guides.
18/2" CLEAR LAMP CORD--250' ROLL-JWH548995 >
NACHI 7212B Angular Contact Ball Bearing, 60 mm Dia Bore, 110 mm OD, 1 Row, 22 mm W, 40 deg, 58000 N Dynamic/46000 N Static Load
The single-row angular contact ball bearing was designed to support radial, axial or composite loads, however, the axial load must be in one direction. The high thrust capacity is achieved by a higher shoulder on one side of the outer ring. A matching high shoulder is often on the opposite side of the inner ring as well. The direction of the load through the balls forms the contact angle. The thrust capacity increases with the contact angle. This ball bearing has a 40 deg contact angle. This bearing has a stamped steel cage and is not available with seals or shields. These bearings are non-separable. These bearings have normal tolerances and are not suitable for mounting adjacent to each other to achieve a preload.
