BBI 400302 Partially Threaded Cap Screw, 1/2-13, 2 in L Under Head, A2 (18-8) Grade, Stainless Steel
BBI 400302 Partially Threaded Cap Screw, 1/2-13, 2 in L Under Head, A2 (18-8) Grade, Stainless Steel
-
BrandBBI
-
Manufacturer Part Number400302
-
CountryUSA
-
MaterialStainless Steel
-
Material SpecificationASTM F593
-
Thread TypeUNC
-
Measurement SystemImperial
-
TypePartially Threaded
-
GradeA2 (18-8)
-
Head Size5/16 in H
-
Head TypeHex
-
Shank Size1/2 in
-
Diameter - Thread Size1/2-13
-
Length Under Head2 in
-
UNSPSC31161501
-
Package Description50/CS
-
Standards/ApprovalsASME B18.2.1
-
Catalog
Recently Viewed
BBI 400302 Partially Threaded Cap Screw, 1/2-13, 2 in L Under Head, A2 (18-8) Grade, Stainless Steel
BBI 400302 Partially Threaded Cap Screw, 1/2-13, 2 in L Under Head, A2 (18-8) Grade, Stainless Steel
3/16" -OD STEEL TUBING .035 WALL-FTG3/16X035 >
McGill® 0000600000 MI Series Standard Machined Separable Inner Ring With Oil Hole and Annular Groove, 3/8 in ID x 0.6245 in OD, 1.01 in OAW, Chrome Steel
Precision ground inner ring provides a hardened raceway for the rollers when used with an unhardened shaft. The ring contains an oil hole and annular groove for relubrication of the bearing and can be used with both CAGEROL® and GUIDEROL® bearings or can be utilized as a bushing in plain bearing applications.
Intertape® 99486 PT14 Specialty UV-Resistant Masking Tape, 54.8 m L x 18 mm W, 5.5 mil THK, Synthetic Rubber Adhesive, Fine Crepe Paper Backing
Intertape® 99486 PT14 Specialty UV-Resistant Masking Tape, 54.8 m L x 18 mm W, 5.5 mil THK, Synthetic Rubber Adhesive, Fine Crepe Paper Backing
SmartlockPro® N7899-HGR 1-Phase Duplex GFCI Receptacle, 125 VAC, 20 A, 2 Poles, 3 Wires, Red
SmartlockPro® N7899-HGR 1-Phase Duplex GFCI Receptacle, 125 VAC, 20 A, 2 Poles, 3 Wires, Red
The 5000® Series of bearings is similar in construction to the 400® Series bearing except it has a flange on the outer ring to locate the bearing when pressed into a tube or housing, thus eliminating the need for an external mounting device. The bearings are designed for moderate loads and speeds where running accuracy and noise level requirements do not warrant the more expensive precision ground bearings. This series of bearings feature a full ball complement without a retainer. The rings are case hardened and the soft steel band on the outer ring of the unitized assembly allows the bearing to be pressed into a housing without the necessity of close housing tolerances. The bearings are supplied pregreased as a standard. The bearings are designed for use in applications with speeds not exceeding 1200 rpm.
