3/8" X 2" USS Elevator Bolts
3/8" X 2" USS Elevator Bolts
-
BrandGeneric
-
Manufacturer Part NumberNBS1290380200
Recently Viewed
3/8" X 2" USS Elevator Bolts
Milwaukee® 48-25-1371 Heavy Duty Standard Self-Feed Wood Drill Bit, 1-3/8 in Dia, 4 in OAL, 7/16 in Shank
Milwaukee® selfeed drill bits deliver speed and Endurance for repetitive drilling of large holes. Designed for any trade that demands woodcutting for installing pipe and conduit, selfeed bits feed into work without pressure and provide faster boring of clean, accurate holes. The bits have improved balance with reduced runout, while the hex shank provides a secure gripping surface for the drill chuck. Every Milwaukee® selfeed drill bit is coated with a rust inhibitor. Built to last and designed to perform, these selfeed bits are resharpenable so you can keep them cutting like new.
HIGH QUALITY PAINT BRUSH FEATURES A SOLID WOOD HANDLE, STAINLESS STEEL FERRULE, WOOD PLUGS AND PROFESSIONAL QUALITY TAPERED FILAMENT. THE FILAMENT IS A 100% ROUNDED POLYESTER BLEND AND IS CHEMICALLY TAPERED FOR A SMOOTH FINISH WITH ALL TYPES OF PAINTS AND FINISHES
-JWH789597>
Gates® Power Transmission Hi-Power® II A98 Banded Heavy Duty V-Belt, A Section, 1/2 in W Top, 100 in L Outside, 5/16 in THK, EPDM
The wrapped classical section Hi-Powerâ„¢ V-belt has a long reputation for reliability on agricultural and industrial applications. The arched top of the Hi-Power belt provides superior strength to prevent "dishing" and distortion of the tensile section. The cords are properly aligned, each of them carrying its full share of the load.
5/16" X 3" X 3/4" NUMBERED BOLT/NUT SEAL - STOSBECONOBOLT>
Koyo TRC-2435 Double Direction Thrust Washer, 38.1 mm ID x 55.55 mm OD, 2.41 mm W
Ideally, a thrust washer should be stationary with respect to and piloted by its supporting or backing member whether or not this is an integral part of the shaft or housing. There should be no rubbing action between the thrust washer and any other machine member. The economics of design, however, often preclude these ideal conditions and thrust washers must be employed in another manner. In such cases, design details should be determined in consultation with your representative.
