MORSE C/Tool 22-MM X 2.50 HAND BOTTOM TAPS MCT 38128
MORSE® 38128 7500 General Purpose Straight Flute Hand Tap, Right Hand Cutting, M22x2.5 Thread, D7 Thread Limit, Bottoming Chamfer, 4 Flutes, Bright, HSS
-
BrandMORSE®
-
UPC686125381288
-
Manufacturer Part Number38128
-
CountryUSA
-
Finish/CoatingBright
-
Thread Length27/32 in
-
MaterialHSS
-
Thread LimitD7
-
Thread SizeM22x2.5
-
Thread StandardGround
-
Chamfer TypeBottoming
-
Measurement SystemMetric
-
TypeGeneral Purpose
-
Series7500
-
Number of Flutes4
-
Cutting DirectionRight Hand
-
Overall Length4-11/16 in
- Straight flute hand taps are used for hand tapping and machine tapping in through holes or blind holes in a wide variety of materials
-
UNSPSC23241615
-
Package Description1/PK
-
Standards/ApprovalsISO 9001:2008
Recently Viewed
MORSE® 38128 7500 General Purpose Straight Flute Hand Tap, Right Hand Cutting, M22x2.5 Thread, D7 Thread Limit, Bottoming Chamfer, 4 Flutes, Bright, HSS
SNW-120X3-7/16 WESCO 3-7/16" SPHERICAL BEARING ADAPTERS
Bore / Shaft Diameter: 3.4375 inches (3-7/16") Overall Length: 100.86 mm (approx. 3.97 inches) Thread Size: 3.918-12Included Components: S-120 sleeve, AN-20 locknut, and W-20 lockwasher Compatible Bearings: 22300K and 23200K series roller bearings
Southwire® Romex® SIMpull® 63950021 Type NM-B Sheathed Cable With Ground Wire, Coil Packaging, 600 V, (3) 6 AWG Stranded Copper Conductor, 25 ft L, Black
Southwire® Romex® Brand SIMpull ® NM-B (nonmetallic-sheathed) cable may be used for both exposed and concealed work in normally dry locations at temperatures not to exceed 90C (with ampacity limited to that for 60C conductors) as specified in the National Electrical Code. NM-B cable is primarily used in residential wiring as branch circuits for outlets, switches, and other loads. NM-B cable may be run in air voids of masonry block or tile walls where such walls are not wet or damp locations. Voltage rating for NM-B cable is 600 volts.
3/4-HP 3-PHASE 56-C 1725-RPM MOTOR - BLDVBM3542>
SANDING BELTS-PRA24011935>
Irwin® Hanson® 8120 General Purpose Straight Flute Tap, Right Hand Cutting, 1/4-20 Thread, Plug Chamfer, (4) Flutes, High Carbon Steel
Irwin 8120 Hanson 1/4"-20 NC HCS Plug Tap - Ideal for tough threading work, routine maintenance, repair and for re-threading where high accuracy and tolerance thread is not critical. Precision ground straight flutes provide rapid chip removal for efficient threading. Tap size and recommended drill bit size are etched on each tool for easy identification. Designed for hand threading work
