Qualtech DWTPT1/8-1SET Pipe Tap Set, Right Hand Cutting, Taper Chamfer
Also called pipe taps, carbon steel NPT pipe taps are designed to clean and or re-thread damaged or jammed pipe threads. They are appropriate for threading a wide variety of materials both ferrous and nonferrous. The nominal size of a Pipe Tap is that of the pipe fitting to be tapped, not the actual size of the tap. The thread tapers 3/4 of an inch per foot. All Pipe Taps furnished with a 2-1/2 to 3-1/2 thread chamfer NPT threads require the use of a sealer like teflon tape or pipe compound.
-
BrandQualtech
-
UPC887861241595
-
Manufacturer Part NumberDWTPT1/8-1SET
-
CountryUSA
-
Finish/CoatingUncoated
-
MaterialCarbon Steel
-
Thread StandardNPT
-
ChamferTaper
-
Measurement SystemImperial
-
SeriesDWTPT
-
Cutting DirectionRight Hand
-
Number of Pieces6
-
Size1/8 to 1 in
-
Package TypeCase
- Carbon steel NPT pipe taps are designed to clean and or re-thread damaged or jammed pipe threads
- They are appropriate for threading a wide variety of materials both ferrous and nonferrous
- The nominal size of a Pipe Tap is that of the pipe fitting to be tapped, not the actual size of the tap The thread tapers 3/4 of an inch per foot
- All Pipe Taps furnished with a 2-1/2 to 3-1/2 thread chamfer
- NPT threads require the use of a sealer like teflon tape or pipe compound
- NPT threads require the use of a sealer like PTFE tape or pipe compound
-
UNSPSC23241615
-
Package DescriptionEACH
-
Standards/ApprovalsPROP65: This product contains Cobalt and/or Nickel and/or Lead a chemical known to the state of California to cause cancer, or birth defects or other reproductive harm. For more information: www.P65Warnings.ca.gov
-
Catalog
Recently Viewed
Also called pipe taps, carbon steel NPT pipe taps are designed to clean and or re-thread damaged or jammed pipe threads. They are appropriate for threading a wide variety of materials both ferrous and nonferrous. The nominal size of a Pipe Tap is that of the pipe fitting to be tapped, not the actual size of the tap. The thread tapers 3/4 of an inch per foot. All Pipe Taps furnished with a 2-1/2 to 3-1/2 thread chamfer NPT threads require the use of a sealer like teflon tape or pipe compound.
Proto® Ergonomics™ J207G Diagonal Cutter Plier With Grip, 1 in L x 7/8 in W x 15/32 in THK Forged Alloy Steel Thin Narrow Jaw, 7-5/16 in OAL, ASME B107.11, Federal GGG-P-468A
CARTRIDGE ROLLS-SAI38302 >
MORSE® DRILL-MILL™ 95355 5989T Regular Length Single End End Mill, 3/4 in Dia, 90 deg Point, 2 Flutes, 1-1/2 in L Flute, 1-1/2 in L of Cut, 3/4 in Dia Shank, 4 in OAL, TiAlN Coated
1/4" JIC HYDRAULIC RUN TEE-DAY660244 >
6-MJIC X 5-MJIC HYD/ADAPTERS-DAY240365>







