MORSE C/Tool 1/4" 3-FL ROUGHING ENDMILLS MCT 44650
MORSE® 44650 4596 Center Cutting Regular Length Single End Roughing End Mill, 1/4 in Dia Cutter, 5/8 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 2-7/16 in OAL, Bright
-
BrandMORSE®
-
UPC686125446505
-
Manufacturer Part Number44650
-
CountryUSA
-
FinishBright
-
MaterialM42 HSS-Co 8
-
Flute TypeFine Pitch
-
TypeCenter Cutting Regular Length Single End
-
Helix Angle30 deg
-
Series4596
-
Cutter Diameter1/4 in
-
Shank Diameter3/8 in
-
Number of Flutes4
-
Cutting DirectionRight Hand
-
Shank TypeRound/Weldon Flat
-
Length of Cut5/8 in
-
Overall Length2-7/16 in
- Roughing end mills feature a chip breaker type cutting edge for heavier cuts, higher speeds and feeds and greatly increased productivity
- Fine pitch is recommended for difficultto-machine, high tensile strength, abrasive and harder materials up to 40 rc
- M42 8% cobalt offers increased wear and heat resistance for abrasive and difficult materials, higher speeds and feeds and long life in production applications
-
UNSPSC23242511
-
Package Description1/PK
-
Standards/ApprovalsISO 9001:2008
Recently Viewed
MORSE® 44650 4596 Center Cutting Regular Length Single End Roughing End Mill, 1/4 in Dia Cutter, 5/8 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 2-7/16 in OAL, Bright
1-1/2" ID NEEDLE BEARINGS-INASC2412>
SYNTHETIC RUBBER TIMING BELT. CONFORMS TO RMA ENGINEERING STANDARD. TIMING BELTS ARE MEASURED BY LENGTH, TOOTH PITCH, THEN WIDTH. THE FIRST NUMBER IS THE LENGTH; THE LETTER AND SOMETIME NUMBER REFER TO THE TOOTH AND THE FINAL NUMBER IS THE WIDTH. STANDARD TIMING TOOTH PROFILE, H; FIBERGLASS TENSIILE MATERIAL; RUBBER OUTER MATERIAL
-JAS480H075 >
APOLLO VALVE LOCKING HANDLE-NIBW648200 >
6-GRV BANDED B-78 V-BELT-JAS6RB78 >
1/4"-MPT #25 NOZZLES-SPM251520 >
