Drillco 3/4" SOLID CARBIDE ENDMILLS DRL 735-A-148-C
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Extra long
-
BrandDrillco
-
UPC045997391076
-
Manufacturer Part Number735A148C
-
CountryUSA|Canada
-
FinishUncoated
-
MaterialSolid Carbide
-
Flute TypeSpiral
-
TypeCenter Cutting Extra Long Length Imperial Single End
-
Helix Angle30 deg
-
Series7350
-
Cutter Diameter3/4 in
-
Shank Diameter3/4 in
-
Number of Flutes4
-
Cutting DirectionRight Hand
-
Shank TypeRound
-
Length of Cut3 in
-
Overall Length6 in
- Solid carbide construction for extreme rigidity and strength
- Center cutting tip for plunging, pocketing and holemaking
- Solid carbide can be ran at 3x the speed and feed of HSS
- 4 flutes produce a better surface finish and less chatter
- Longer flutes for deeper or hard to reach cuts
- Bright finish for added lubricity
-
UNSPSC27112803
-
Package Description1/PK
-
Standards/ApprovalsPROP65: This product can expose you to chemicals including Cobalt, which is [are] known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
-
SDS
-
Catalog
Recently Viewed
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Extra long
7-1/2-OZ PUMP-STYLE DIAL SOAP-PG-80766 >
Gates® Power Transmission Hi-Power® II CC96 Banded Heavy Duty Double V-Belt, CC Section, 7/8 in W Top, 100 in L Outside, 23/32 in THK, EPDM
Designed with a unique recessed top and bottom to maintain sidewall contact, while remaining flexible for belt drive applications that require power transmission from both sides of the belt.
1-5/8" -ID LOW PILLOW BLOCK UNIT-MBUVPLE226 >
Drillco 72A164C 7200 Center Cutting Imperial Regular Length Single End Finishing End Mill, 1 in Dia Cutter, 1-1/2 in Length of Cut, 2 Flutes, 1 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life.
Carborundum® CARBO GOLD™ 05539509277 Small Diameter Cut-Off Wheel, 2 in Dia x 0.035 in THK, 1/4 in Center Hole, A60 Grit, Aluminum Oxide Abrasive
