Drillco 735A116C 7350 Center Cutting Extra Long Length Imperial Single End Finishing End Mill, 1/4 in Dia Cutter, 1-1/2 in Length of Cut, 4 Flutes, 1/4 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Extra long
-
BrandDrillco
-
UPC045997391014
-
Manufacturer Part Number735A116C
-
CountryUSA|Canada
-
FinishUncoated
-
MaterialSolid Carbide
-
Flute TypeSpiral
-
TypeCenter Cutting Extra Long Length Imperial Single End
-
Helix Angle30 deg
-
Series7350
-
Cutter Diameter1/4 in
-
Shank Diameter1/4 in
-
Number of Flutes4
-
Cutting DirectionRight Hand
-
Shank TypeRound
-
Length of Cut1-1/2 in
-
Overall Length4 in
- Solid carbide construction for extreme rigidity and strength
- Center cutting tip for plunging, pocketing and holemaking
- Solid carbide can be ran at 3x the speed and feed of HSS
- 4 flutes produce a better surface finish and less chatter
- Longer flutes for deeper or hard to reach cuts
- Bright finish for added lubricity
-
UNSPSC27112803
-
Package Description1/PK
-
Standards/ApprovalsPROP65: This product can expose you to chemicals including Cobalt, which is [are] known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
-
SDS
-
Catalog
Recently Viewed
Drillco 735A116C 7350 Center Cutting Extra Long Length Imperial Single End Finishing End Mill, 1/4 in Dia Cutter, 1-1/2 in Length of Cut, 4 Flutes, 1/4 in Dia Shank, 4 in OAL, Uncoated
Solid carbide end mills run at extremely impressive feed and speed rates. In some cases, they can be run at 3x the rates of HSS end mills. Using solid carbide end mills results in better surface finish on the workpiece and extended tool life. Extra long
Drillco 695A124A 6950A Center Cutting Double End Imperial Regular Length Finishing End Mill, 3/8 in Dia Cutter, 3/4 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 3-1/2 in OAL, Uncoated
The greater red hardness of M-42 Cobalt end mills enables these tools to run about 10% faster than conventional HSS end mills. This translates to shorter machining times and permits higher utilization of available machine horsepower.
MORSE® 57279 5946 Center Cutting Double End Stub Length End Mill, 7/16 in Dia Cutter, 9/16 in Length of Cut, 4 Flutes, 7/16 in Dia Shank, 3 in OAL, Bright
15/16" -ID 4-BOLT FLANGE UNIT-MBUVF4S215 >
1000-W 120-VOLT MOGUL BASE CLEAR BULB-BUL1000 >
Rust-Oleum® 2391838 2300 System High Performance Water Base Inverted Striping Paint, 18 oz Container, Liquid Form, White, 275 to 300 linear ft/gal with 3 in W Stripe Coverage
