Roughing End Mills
Drillco 714A164M 7140 Center Cutting Imperial Multi-Flute Regular Length Single End Roughing End Mill, 1 in Dia Cutter, 2 in Length of Cut, 5 Flutes, 3/4 in Dia Shank, 4-1/4 in OAL, Uncoated
Roughing end mills are designed for extremely rapid stock removal. These end mills can remove material up to 3x the rate of regular end mills. Designed to machine low alloy, high strength steels at faster feed and speed rates.
Recently Viewed
Type / Series: Type B, Type S Sensing Method: Melting alloy Trip Class: Class 20 (trips in 20 seconds or less under overload conditions) Mounting Style: Plug-in / Plug-on Voltage Rating: Up to 600V maximum Amperage Range: The exact Full Load Amps (FLA) rating depends entirely on your specific motor starter size, enclosure type, and phase configuration. Across various applications, its current rating spans from 7.54 to 9.55 Amps. For instance, a standard NEMA starter setup typically rates it around 7.84 to 8.47
A small square-shaped dressing designed to fit the palm of the hand, a commonly burned area, or the back of the hand, near the knuckles.
KLEENAIRE
MILWAUKEE® diamond wet core bits are designed to the highest standards, only using quality diamonds. Available in sizes 1 in. to 6 in., MILWAUKEE® pre-stressed wet core bits are designed specifically for the extra demands of drilling pre-stressed concrete. The cutting segments feature small gaps, preventing the bit from snagging on pre-tensioned cables or wire mesh. This bits is 15 in. in length and contains a 5/8 in. 11 thread.
HANDYMAN SCREWDRIVER 8" STANDARD-STA64868>
3/4"-CUT RIVETBUSTER 5/8"-HEX 12"-LONG - ALL25666 >
