metabo® 676016000 2-Cutter Hammer Drill Bit, 1/2 in Drill Bit, Spline Shank, 5 in D Cutting, Carbide Cutting Edge, 10 in OAL
metabo® 676016000 2-Cutter Hammer Drill Bit, 1/2 in Drill Bit, Spline Shank, 5 in D Cutting, Carbide Cutting Edge, 10 in OAL
-
Brandmetabo®
-
UPC662911880326
-
Manufacturer Part Number676016000
-
CountryUSA
-
MaterialCarbide
-
Flute Length5 in
-
Flute TypeSpiral
-
Type2-Cutter
-
Applicable MaterialsMasonry
-
Number of Flutes2
-
Cutting Depth5 in
-
Cutting Edge MaterialCarbide
-
Shank TypeSpline
-
Drill Bit Size1/2 in
-
Overall Length10 in
- Unique head design reduces friction in the hole resulting in faster drilling speed and maximum bit life
- Large volume double spiral flutes provide rapid dust removal further enhancing bit life and drilling speed
- Drills precise round holes for ease of anchor installation and stronger anchor holding
- Patented flute design minimizes vibration and noise thus protecting both tool and operator
-
UNSPSC20111603
-
Specification Sheet
Recently Viewed
metabo® 676016000 2-Cutter Hammer Drill Bit, 1/2 in Drill Bit, Spline Shank, 5 in D Cutting, Carbide Cutting Edge, 10 in OAL
metabo® 676016000 2-Cutter Hammer Drill Bit, 1/2 in Drill Bit, Spline Shank, 5 in D Cutting, Carbide Cutting Edge, 10 in OAL
Milwaukee® 48-25-4125 Standard Self-Feed Bit, 4-1/8 in Dia, 4 in OAL, 7/16 in Shank
Milwaukee® Selfeed drill bits deliver speed and endurance for repetitive drilling of large holes. Designed for any trade that demands woodcutting for installing pipe and conduit, Selfeed bits feed into work without pressure and provide faster boring of clean, accurate holes. The bits have improved balance with reduced runout, while the hex shank provides a secure gripping surface for the drill chuck. Every Milwaukee Selfeed drill bit is coated with a rust inhibitor. Built to last and designed to perform, these Selfeed bits are resharpenable so you can keep them cutting like new. Two feed screws are included.
Irwin® 5026015 501 Rotary Hammer Drill Bit, 1/2 in Drill Bit, 3/8 in Round Shank, Tungsten Carbide Cutting Edge, 6 in OAL
Tungsten carbide tip is durable when drilling in concrete and brick. Deep single flute removes dust fast for increased drilling speed and longer bit life. Diamond ground tip has aggressive cutting angles for increased drilling speed. Fits all hammer drills with 3-jaw or Jacobs chuck.
16-OZ BRASS PLUMB BOBS--308760-GNL80016 >
Irwin® 5026020 Rotary Masonry Drill, 5/8 in Drill Bit, Round Shank, Tungsten Carbide Cutting Edge, 13 in OAL
Tungsten carbide tip is durable when drilling in concrete and brick. Deep single flute removes dust fast for increased drilling speed and longer bit life. Diamond ground tip has aggressive cutting angles for increased drilling speed. Fits all hammer drills with 3-jaw or Jacobs chuck.
Dremel® 8175 Grinding Stone, Cylindrical Point, 9.5 mm Dia, 3.2 mm Dia Shank
