Morse 350-TL (540) PB TOR/LIMIT BUSHINGS MRE 604107
Sintered steel bushing on which the center member and friction facings rides are coated with a dry film lubricant; therefore, no oil is present to contaminate friction facings and reduce torque capacity. The bushing "free floats" on the hub. Morse® offers a wide selection of bushing widths in all torque limiter sizes, permitting close matching of center member and bushing width to minimize bearing pressure and promote longer bushing life.
-
BrandMorse®
-
UPC662288494942
-
Manufacturer Part Number604107
-
CountryUSA
-
MaterialSintered Steel
-
Dimensions0.54 in L
-
Suitable For Use With350A Series Plain Bore Torque Limiter
- Morse and Browning offer a complete line of Torque Overload Devices to protect machinery from overloads or jams
- Bushing kits are available in a wide range of bore size and are easily installed
- The load on the friction pads is adjusted so that process torque is transmitted
- An overload causes the unit to slip
- Morse torque limiters are simple design, economical, easy adjustment, compact and dependable
-
Alternative Part Number350 TL BUSHING (540)PB
-
UNSPSC40161515
-
Package DescriptionEACH
-
Specification Sheet
-
Instruction/Installation Manual
Recently Viewed
Sintered steel bushing on which the center member and friction facings rides are coated with a dry film lubricant; therefore, no oil is present to contaminate friction facings and reduce torque capacity. The bushing "free floats" on the hub. Morse® offers a wide selection of bushing widths in all torque limiter sizes, permitting close matching of center member and bushing width to minimize bearing pressure and promote longer bushing life.
Browning® shear pin hubs are designed to shear a necked pin at a predetermined load. This protects equipment from overloads. Consisting of a hub assembly, a sprocket and shear pin, the shear pin bridges between the sprocket and hub assembly. The shear pin is available in load increments, so the closest one to your application requirements must be chosen. Resetting the shear pin hub is accomplished manually by replacing the shear pin. Best applied to applications where infrequent overloads are encountered.
14" 120# UV BLACK CABLE TIE-BAG OF 100-CTE14120UV100 >
These pliers are used to easily remove or install spring / flat band type hoe clamps. The cable allows the user to snake the clamp remover in and reach clamps in the most remote or difficult access areas. The innovative dual sided device will work on an expanded range of clamps from 0 to 2" and from 1" to 3".
DRILL DOCTOR DRILL BIT SHARPENER - JWH315958 >
180-GRIT DRILL DOCTOR DIAMOND WHEEL - JWH315966>

