Moline Bearing 19321300 Type E Pillow Block Bearing, 3 in Dia Bore, 8-13/16 in L Bolt Center-to-Center, 3-1/8 in Base to Bore Centerline, 12 in OAL x 6-5/16 in OAH
Made of Cast Iron, this Solid Type E 2-Bolt Pillow Block is a Non-Expansion Mounted Roller Bearing Bearing with a 3 in (3.0000 in) shaft size. Includes a Steel Set Screw Locking Insert with a Double Collar, an available Standard V-Guard Contact Seal made of Nitrile, and a Standard Painted finish, this bearing is ready for even the toughest of jobs.
-
BrandMoline Bearing
-
Manufacturer Part Number19321300
-
CountryUSA
-
TypeType E
-
Mounting Type2-Bolt
-
Base Width3 in
-
Base to Bore Centerline3-1/8 in
-
Bolt Center-to-Center Length8-13/16 in
-
Bore Diameter3 in
-
Overall Height6-5/16 in
-
Overall Length12 in
-
Overall Width4-1/2 in
-
Package DescriptionEACH
Recently Viewed
Moline Bearing 19321300 Type E Pillow Block Bearing, 3 in Dia Bore, 8-13/16 in L Bolt Center-to-Center, 3-1/8 in Base to Bore Centerline, 12 in OAL x 6-5/16 in OAH
Made of Cast Iron, this Solid Type E 2-Bolt Pillow Block is a Non-Expansion Mounted Roller Bearing Bearing with a 3 in (3.0000 in) shaft size. Includes a Steel Set Screw Locking Insert with a Double Collar, an available Standard V-Guard Contact Seal made of Nitrile, and a Standard Painted finish, this bearing is ready for even the toughest of jobs.
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
Drillco 675A148D 6750A Center Cutting Imperial Long Length Single End Finishing End Mill, 3/4 in Dia Cutter, 3/4 in Length of Cut, 4 Flutes, 3/4 in Dia Shank, 3 in OAL, Uncoated
The greater red hardness of M-42 Cobalt end mills enables these tools to run about 10% faster than conventional HSS end mills. This translates to shorter machining times and permits higher utilization of available machine horsepower.
DECKER HUMP HILL'S RINGS--PIG, SHOAT, AND HOG SIZES ARE MADE WITH A SLIGHT BEND OR HUMP IN THE CENTER SO THEY CLOSE EASILY. MADE OF DURABLE COPPER-COATED STEEL.
-JWH714766 >
MORSE® 58158 5955 Center Cutting Long Length Single End End Mill, 7/16 in Dia Cutter, 2 in Length of Cut, 4 Flutes, 7/16 in Dia Shank, 4 in OAL, Bright
DOUBLE SHIELDED BALL BEARING WITH SNAP RING-GUL63072ZNR >
