Sealmaster 1-7/8"-ID PILLOW BLOCK UNITS SEA NPD-30
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
-
BrandSealmaster®
-
UPC662461015483
-
Manufacturer Part Number702107
-
CountryUSA
-
Load Capacity7889 lb Dynamic
-
Locking DeviceDouble Set Screw
-
Temperature Rating250 deg F
-
FinishUncoated
-
MaterialCast Iron
-
Maximum Speed5000 rpm
-
TypeStandard-Duty
-
Mounting TypeTwo-Bolt Base
-
Seal TypeFelt
-
SeriesNPD
-
Base Width2-3/8 in
-
Base to Bore Centerline2-1/4 in
-
Bolt Center-to-Center Length6 to 6-1/2 in
-
Bore Diameter1-7/8 in
-
Bore TypeRound
-
Expansion TypeNon-Expansion (Fixed)
-
Overall Height4-9/16 in
-
Overall Length8-1/8 in
-
Overall Width2-1/2 in
- Wide outer ring
- Lock pin and dimple
- Zone hardened inner race
- Land riding retainer
- Housing fit
- Metal nameplate riveted to the housing allows for easy identification even after years of operation
- GoldPlex®-HP grease
- Alemite fitting lubrication
- 52100 black oxide coated steel insert
-
Alternative Part NumberNPD-30
-
UNSPSC31171504
-
Instruction/Installation Manual
-
Catalog
-
Specification Sheet
Recently Viewed
Sealmaster® gold mounted ball bearings feature a wide outer race insert bearing with land riding metallic retainer. The black oxide treated bearing steel insert features an exclusive lock pin and dimple system providing a direct path for lubrication into the bearing, and prevents outer ring rotation within the housing. Shaft lock is achieved by either setscrew or Skwezloc® concentric locking collar. The felt seal with flinger provide a good balance between contaminant entry, GoldPlex® HP grease loss and friction. Depending on your preference, these bearings are available in both inch and metric shaft sizes with a wide variety of cast iron, stamped steel or rubber mount housings, sealing, and lubrication options or industry specific solutions.
Carhartt® CHB810ST Safety Glasses, Anti-Fog/Anti-Scratch, Clear Lens, Black/Tan, Polycarbonate Frame, ANSI Z87.1+, CAN/CSA Z94.3-15, CE EN166
Milwaukee® 49-90-0400 Crevice Tool, For Use With 12552 1-1/2 in ID Hose, 15 in, Metal
For cleaning behind radiators and other hard to reach places use the Milwaukee® 15 in crevice tool. Attaches to 1-1/2 in ID hoses.
ECONOMY FORD ENGINE RED SPRAYPAINT-KRYB30 >
8-OZ HAND SANITIZERS-JWH630667>
Browning® mounted ball bearings feature multiple housing styles, materials and configurations, an extended inner race insert bearing with ball riding nylon retainer. The insert features a rivet to prevent outer ring rotation and is available with setscrew, eccentric or BOA concentric locking collar. The contact seal with black oxide treated flinger provides a good balance between contaminant resistance, grease loss and friction.
