Plain Sleeve Hanger Bearings
Martin CHB2203N S/CHB Type 220 Plain Sleeve Hanger Bearing, 1-1/2 in Dia Bore, Nylatron Bearing
Nylatron bearings are used as support bearings for drive and screw conveyor shafts. This self-lubricating hanger bearing can withstand temperatures up to 250 deg F and is compatible with 220 and 19B style hangers. It is recommended for grain, feed and chemical handling applications due the very low load capacity attribute.
Martin CHB2204W S/CHB Type 220 Plain Sleeve Hanger Bearing, 2 in Dia Bore, Wood Bearing
Wood bearings are used as support bearings for drive and screw conveyor shafts. It is self-lubricating and able to withstand temperatures up to 160 deg F. This style bearing is ideal for intermediate hangers that convey moderately abrasive materials as well as grain, feed and fertilizer applications.
Recently Viewed
Tsubaki® DS80A14 Type A Double Single Roller Chain Sprocket, 1 in Dia Bore, 4.98 in OD, 80 Chain, 14 Teeth, 1 in Pitch, Carbon Steel
This type of sprocket is commonly used in applications where two or more items are powered by a common drive shaft. The space between the sprocket plates is wider than a multi-strand sprocket and allows two separate strands of chain to engage without contacting each other. With this type of sprocket, one strand of chain may exit in a different direction than the other. For example, one strand exiting towards the ceiling and the other running parallel to the floor.
PTI 10B-31B Single Strand Hub Type B Roller Chain Sprocket, 20 mm Dia Bore, 163.9 mm OD, #10B-1 Chain, 31 Teeth, 15.875 mm Pitch, C45 Steel
Hub type metric sprockets are available with a minimum plain bore (pilot bore) and some stock finished bore sizes. Any shaft size is possible with our custom bore and keyway capability. Sprockets with hubs are typically fitted to the shaft as a clearance fit. They are held in place with two set screws and a keyway. Clearance fits are popular for light loads and slow speeds. A press fit (or shrink fit to the shaft) is usually preferred for higher speeds or heavier loads as they fit to the shaft more securely than a clearance fit sprocket. Depending on the clearance of the shaft fit, sprockets may work slightly on the shaft causing possible fretting or shaft wear. All sprockets are available with hardened teeth from stock or on request. Press fits usually require the sprocket to be heated for installation to expand the bore. As a heated sprocket cools, it shrinks, conforming to the shaft with a tight grip. A set screw can be used to secure the key. The TL taper bushed sprocket will function like the press fit sprocket and is generally easier to install.
Browning® 1112077 Double Single Strand Plate Type A Roller Chain Sprocket With Hardened Teeth, 5/8 to 1-7/8 in Dia Bore, 3.72 in OD, 50 Chain, 17 Teeth, 5/8 in Pitch, Steel
Browning® offers type A plate steel sprockets in single strands. Offerings include 25 to 200 pitch range.
