R-20 Double Open Face Ball Bearing
DOUBLE OPEN FACE BALL BEARING - GULR20>
Recently Viewed
DOUBLE OPEN FACE BALL BEARING - GULR20>
BBI 087552 Fully Threaded Cap Screw, 3/4-16, 2-1/2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 087552 Fully Threaded Cap Screw, 3/4-16, 2-1/2 in L Under Head, 5 Grade, Carbon Steel, Zinc CR+3
BBI 455414 Partially Threaded Cap Screw, 9/16-18, 3-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
BBI 455414 Partially Threaded Cap Screw, 9/16-18, 3-1/2 in L Under Head, 8 Grade, Alloy Steel, Zinc Yellow Bake CR+6
Weiler® 08178 ST-10 Heavy-Duty Wheel Brush, 10 in Dia Brush, 3/4 in W Face, 0.014 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 3/4 in Arbor Hole
Weiler® 08178 ST-10 Heavy-Duty Wheel Brush, 10 in Dia Brush, 3/4 in W Face, 0.014 in Dia Filament/Wire Standard/Twist Knot Filament/Wire, 3/4 in Arbor Hole
180-GRIT DRILL DOCTOR DIAMOND WHEEL - JWH315966>
The Browning® torque limiter is a spring loaded friction style torque overload device. The load on the friction pads is adjusted so that the process torque is transmitted. An overload torque in excess of the set torque causes the unit to slip. This prevents overloads from transmitting through the system. When the load falls below the set level, the torque limiter stops slipping and transmits the torque. A torque limiter does not maintain phase between input and output. Although it is a similar size, the Browning® torque limiter has a higher torque density than the Morse® torque limiter. It is also well suited for applications that trip infrequently at high loads. It is most often used in a chain drive. A specially machined sprocket is inserted between the friction pads and acts as the slip interface. Torque capacity is up to 8800 in-lb.
