CONS WC87009 Deep Groove Ball Bearing, 9 mm Dia Bore, 30 mm Dia Outside, 0.5 in W
CONS WC87009 Deep Groove Ball Bearing, 9 mm Dia Bore, 30 mm Dia Outside, 0.5 in W
-
BrandCONS
-
UPC644075203562
-
Manufacturer Part NumberWC87009
-
CountryUSA
-
Cage MaterialSteel
-
Closure TypeSingle Felt Seal/Single Shield
-
TypeDeep Groove
-
Width0.5 in
-
Outside Diameter30 mm
-
Bore Diameter9 mm
- Low friction and are optimized for low noise and low vibration which enables high rotational speeds
- Newer design bearings are supplied with rubber seals instead of felt seals
- Width dimensions may vary between manufacturers
-
Package DescriptionEACH
Recently Viewed
CONS WC87009 Deep Groove Ball Bearing, 9 mm Dia Bore, 30 mm Dia Outside, 0.5 in W
CONS WC87009 Deep Groove Ball Bearing, 9 mm Dia Bore, 30 mm Dia Outside, 0.5 in W
7/8-HOSE X 1"-MPT 100R5 COUPLING-DAYR50116X16>
Precision Brand® 16AN20 Flat Sheet Shim Stock, 1008-1010 Full Hard Steel, 18 in L x 6 in W x 0.02 in THK
Steel shim is made from a full hard, cold rolled, low carbon 1008-1010 steel. Precision Brand® is the only manufacturer to offer Branded® shim. It has everything the user needs to know clearly marked right on the shim: material type, material thickness and lot # for full traceability. Used in applications where hardness, flatness and accuracy are required. Material can be punched or sheared with minimum burring and distortion. Precision Brand® shim stock is widely used in the following applications: tool and die set up, alignment, new machine assembly, machine repair and maintenance; mounting of motors, pumps and other machines, short run and prototype work, along with a variety of other industrial uses. It is especially useful for pilot production runs where material accuracy and economy are important. All Precision Brand® shim products are manufactured under rigorous quality control standards to assure high accuracy and tight tolerances.
2.5 SQ FT AUTO DRYING CLOTH-PRI114250 >
Precision Brand® 16A12 Shim Stock, 1008-1010 Full Hard Steel, 100 in Roll L x 6 in W x 0.012 in THK
Steel shim is made from a full hard, cold rolled, low carbon 1008-1010 steel. Precision Brand® is the only manufacturer to offer Branded® shim. It has everything the user needs to know clearly marked right on the shim: material type, material thickness and lot # for full traceability. Used in applications where hardness, flatness and accuracy are required. Material can be punched or sheared with minimum burring and distortion. Precision Brand® shim stock is widely used in the following applications: tool and die set up, alignment, new machine assembly, machine repair and maintenance; mounting of motors, pumps and other machines, short run and prototype work, along with a variety of other industrial uses. It is especially useful for pilot production runs where material accuracy and economy are important. All Precision Brand® shim products are manufactured under rigorous quality control standards to assure high accuracy and tight tolerances.
.004 FEELER GAUGE STRIPS-OHSFS004 >
