Weiler® 13085 Narrow Face Wheel Brush With Nut, 4 in Dia Brush, 1/2 in W Face, 0.014 in Dia Crimped Filament/Wire, 5/8-11 Arbor Hole
Weiler® 13085 Narrow Face Wheel Brush With Nut, 4 in Dia Brush, 1/2 in W Face, 0.014 in Dia Crimped Filament/Wire, 5/8-11 Arbor Hole
-
BrandWeiler®
-
UPC012382130855
-
Manufacturer Part Number13085
-
CountryUSA|Canada
-
Face Width1/2 in
-
Filament/Wire Diameter0.014 in
-
Filament/Wire TypeCrimped
-
Fill MaterialStainless Steel
-
Maximum Speed14000 rpm
-
Trim Length7/8 in
-
TypeNarrow Face
-
Arbor Hole Size5/8-11
-
Attachment TypeThreaded Arbor
-
Brush Diameter4 in
- Crimped wire wheels with a threaded nut are intended for use primarily on small angle grinders
- Featuring Weiler's solid ring construction, these radial brushes are available in heat treated steel and type 302 stainless steel wire
- 7/16 in T of face plate
| Competitor Name | Competitor Part Number |
|---|---|
| Fastenal | 0811744 |
-
UNSPSC31171805
-
Package Description5/PK
-
Standards/ApprovalsANSI B165.1|CSA Approved
-
Catalog
Recently Viewed
Weiler® 13085 Narrow Face Wheel Brush With Nut, 4 in Dia Brush, 1/2 in W Face, 0.014 in Dia Crimped Filament/Wire, 5/8-11 Arbor Hole
Weiler® 13085 Narrow Face Wheel Brush With Nut, 4 in Dia Brush, 1/2 in W Face, 0.014 in Dia Crimped Filament/Wire, 5/8-11 Arbor Hole
3-15/16" SPLIT PILLOW BLOCK HOUSING-BCCSAF522 >
15 TOOTH SPROCKETS FOR #35 CHAIN-IDC35B15F7/8 >
ASP-200-2-SSS Industry Standard Clamping Collar, 2-Piece Construction, 2 in ID x 3 in OD x 11/16 in W, Stainless Steel
Stainless Steel Two-Piece Clamping Collar. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Greater axial holding power than set screw or one-piece clamping collars. Effective on hard & soft shafts.
MORSE® 57921 5943 Center Cutting Regular Length Single End Mill, 21/64 in Dia Cutter, 1 in Length of Cut, 4 Flutes, 3/8 in Dia Shank, 2-1/2 in OAL, Bright
Dichtomatik N70115 O-Ring, 115 Dash Number, 0.674 in ID x 0.88 in OD, Nitrile Rubber, 70 Shore A Durometer, Import
O-rings are closed circular rings of circular cross-section. They are made through vulcanization from form tools as a complete ring. The sealing function of the O-ring is achieved by the deformation of the cross-section when installed and compressed in its housing. The O-ring can be compressed either radially or axially in its installation housing. In operating conditions the pressure exerted by the media reinforces the sealing function, as under pressure the elastomer material functions as a non-compressible fluid.
