V-BELTS A-B-C-D-E
A-31 BROWNING Browning A23 Super Grip Belt Features: - 25.2 Inch OD. - A Section. - Neoprene With Rubber.
A31 classical V-belt designation
Neoprene wrapped construction for durability
Up to 95% efficiency rating
Resistant to heat, oil, and wear
A-34 BROWNING 1/2" x 5/16" Super Gripbelt w/ 35.3 Pitch
Wrapped construction - Provides smooth quiet operation. Single fabric design allows greater flexibility. Wrapped Belts are more tolerant to slipping and misalignment than Raw Edge Belts.
Close Belt tolerance - Browning Belts offer the "Code 1" Match belt system on all classical and "358" Belts, allowing easy selection of just one match number for each belt size. This ensures tighter than RMA standards.
High Tensile Cord - Specially treated cords to provide strength and additional flex life while providing resistance to elongation for the belt.
A-35 BROWNING 1/2" x 5/16" Super Gripbelt w/ 36.3 Pitch
Browning® - A35 Gripbelt® V-Belt (37.2" Outside Length)
EPDM Material
Operating Temperatures: -60F to +250F
Ground Form
Reduced vibration increases belt and bearing life.
Fabric Top and Bottom
Increases rigidity and stability.
Reduces stress on the cord line and increases belt life.
Wider Notch Spacing
Increases rigidity and stability.
Reduces stress on the cord line and increases belt life.
Recently Viewed
Locking ring allows for quick vertical height adjustments
Retains the V Head to the tube for quick adjustments
Maximum weight capacity is 2500 pounds (1134 kg)
Pipe stand has a 12-inch (300 mm) pipe capacity and 28-inch to 52-inch (71 cm to 132 cm) height adjustment
RIDGID covers its products with a lifetime warranty against defects in material or workmanship for the life of the tool
Proto® TorquePlus™ J5422M Standard Length Socket, Metric, 1/2 in Square Drive, 22 mm
.901" INTERNAL RETAINING RING-ANR1400255 >
Proto® J5454F Non-Insulated Hand Ratchet, Imperial, 1/2 in Drive, Round Head, 15 in OAL, Steel, Full Polished
3-1/2" -MALE PIPE THREADX3" -FEMALE PIPE THREAD BLACK BUSHING-JPW31/2X3BB >
Milwaukee® 48-13-6250 Heavy Duty Solid Center Ship Auger Bit, 1-1/4 in Dia, 18 in OAL, 15 in L Spiral Flute, 7/16 in Shank
The Milwaukee® 1-1/4 in. x 18 in. Ship auger bit drills through up to 2X the nails of competitive auger bits without needing resharpening. Drill into clean or nail-embedded wood with confidence when installing Romex wire, PEX water lines, rebar, bolts, and rope in piers, playground equipment and landscaping. The flutes are wider for maximum chip removal, even in deep holes. The polished and coated flute finish means chips won't stick to the bit, even when drilling in material that contains sap or glue. The through-center cutting design creates a more solid striking point against nails compared to the competitions' ahead-of-center and behind-center designs. The longer shaft length makes it easy to drill deeper or overhead without an extension.
